Leaderboard

First-the enclosure specs for 15 inch xcons have a standard and optimal size. What are the key differences in the two? Also-I had to sell one of my amps to get through a hard time. My question is, powered by a fosgate t1500bdcp amp, should i run one sub ported at 2 ohm or both of them sealed at 1 ohm?

Have a good one.

jecar does amazing boxes...I follow them on facebook.

That build is fantastic. I love the stain and the scorpions. Congratulations to the builder and the owner.

I'm not doing any of this, this is all Daniel and Eric. I do have a question for you, did you have an issue with charging too high or too low? I was told that I will charge too high if I don't ground through the factory box that was where the alts are now? No I sit right at 14.8 when my alts are on... I have a switch to turn my two externally regulated alts on and than and internal regulated to keep my factory battery dash light off...but did not have a problem at all

Man i love giant surfboard amps.. Everyone wants smaller and smaller. I say bigger the better.

I just hire hot chicks to wash my vehicles with their boobs and car wash, works wonders.

Happy Berfday Neal! I always miss these things.

It's not an argument. No one disagrees with the fact that it's wear on the paint. Its just about how much work is worth a certain result.

Right on. If you ever visit JC again hit me up. I work literally right across from the mall in Pauls Mall.

I see your from Johnson City,I used to go there to the mall all the time when I lived in Oak Ridge. Always nice to see people from TN posting. For sure. I've been here around 10 years now. We just bought a house in fall branch. We like it well enough. Where you at now?

I did a mock up and those dimensions look like gold to me. Thanks again bud.

Yes please! ALso the bottom measurement of 17 inches is a definate. It was hard to measure the top to make them perfectly straight up and down. Does that make sense? Basically if the top of box is going to lean out on the front because of my measurements, feel free to adjust. Also im considering putting some polyfill in to help a little. Thoughts?

The box will be a "wedge" design with the slant on the back side as to fit against my back seats. 45.5" wide 16" high 12" top panel 17" bottom panel Hopefully that makes sense im not sure how to label them or how to figure out how big the "slanted" panel should be. Just let me know if you need any other info. Thanks!

Thanks my SSA brothers. I spent the day with Aaron watching the O's have another home run walk off win and rounded the night out with drinks.

Happy birthday brother!

HBD and congrats on another orbit around the local star! You are one heck of a guy and I hope you have a blast today and all year!

Happy Birthday!

Happy Birthday !!

Party , party, party. Enjoy it Nem

Happy birthday bro!!!!!

Will do. Hopefully ill have Alton helping me with a box in a bit. Thanks.