Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 08/06/2017 in all areas

  1. 1 point
  2. 1 point
    As a side note when i had the 8 18 icons i had two soundstream 6500s that i was running at 16volt and the difference from 14 to 16 was noticeable...... On my pockets. It was such a hassle if its going to be a daily then the KISS method is what to follow. When you mix 14 and 16 and drive it daily it turnz fugly.
  3. 1 point
    Transpo regulator. The blue one. If your only running 1 secondary alt then the transpo will be just fine. My yukon is setup with triple alts. 1 stock and 2 for the system. I still only run it at 14.8 but i love not having my truck and my system on the same lifeline.
  4. 1 point
    I'v built a few thousand enclosures over the last ( almost 30 years ) and I have tested them with air pressure and a sledge hammer to make Shure my product is as close to indestructible as possible the enclosures that I used only glue and Brad nails can be hammered apart panel by panel with laminate layer damage on all seams but the enclosures that were screwed as well had to be hammered into a pile of scrap to come apart and they don't blow apart at the seams with 120psi of positive pressure inside you can call my testing overkill but it proves that screws increase the strength of an enclosure by a long shot This is why all my enclosures were sold with a LIFETIME warranty against coming apart at the seams under normal use conditions
  5. 0 points
    No sir i dont run crossfire. Its either Fi or SSA products for me. I have ran every series of the SSA line and i love every single one. But currently im not playing cause motor blew on my way to work in the konvikt. But when its back up it will be 4 Team Fi 18z on 2 soundigital 12k.
×