Been a while guys. I've made some progress despite the difficulties of working on things in my apartment.
I think I got carried away with the size of these enclosures.
These are my baffles, the ring is 3d printed petg. The white speaker mount is also 3d printed and will allow me to swap in other drivers easily.
Starting the enclosures. Pretty standard stuff. I decide to build enclosure that sit on the dash rather then build off the A pillar. In retrospec I think it might have been better to put the 4 on the pillar and tweeter in the sail panel to cut down the size of these monsters.
Next I aimed the speaker baffles
the left side has to come out towards the driver quite a bit. I hope this doesn't kill imaging too badly.
The pods where difficult to wrap, even with this spandex material I used.
My solution to the creases in the fabric.
After the first coat of resin on the spandex
Test fit
ya these look toooo big...
Had to flock the enclosures in my kitchen... not the best idea