kwalson07

oh and for everyone that thinks im a busta i work a lot my bad guys

What was the issue? the way i wired the positive and negative to my amp [+] [+] [-] [-] 1 2 3 4 i tried 1 and 4 then 1 and 3 finally i did 2 and 4 and my sub was working not slappin as hard as i thought it would tho maybe it needs to be broken in more but i think it should be louder then what it is

got ,my amp working finally thanks for the help you guys appreciate it

i havent changed the wiring at all so yeah it was wired in series on the other amp too if its in series, and its a single driver dual 1ohm then its going to put a 2ohm load on your amp, which is fine i just dont get why my sub isnt bumping tho i had it bumping yesterday on my other amp and it was fine i got my new amp today hooked it all up, made sure everything was good went to play some music and no bass whats music without bass haha

i havent changed the wiring at all so yeah it was wired in series on the other amp too

You have the coils wired in series then? If it were wired in parallel instead that would present a .5 ohm load at the amp which SHOULD probably put the amp into protection and cause it to not play anything. Though that would really depend on the amp and how the protection circuitry is designed. Do you have a DMM? Also, have you checked both ends of your RCA's to verify they're still plugged in? (sounds silly, but I've seen it happen) Can you re-install your old amp and verify everything is working? There is ALWAYS a chance that the new one is bad out of the box. While it's VERY rare, it does happen. so since i have my sub wired in series and my amp is parallel it wont work? if i re wire the sub to a .5 load, and my amp goes into protection is that bad or a good sign? whats DMM?

RCA's are plugged into input tried tinkering around with the gain to see if the sub made any noise and nothing , i could try again tho speaker connection at the terminals, does that mean how i have it wired like since mt sub is a dual 1 ohm, i wired it at 2 ohms ?

sorry fellas amp gets power doesn't go into protection didn't touch the wiring of the sub checked my ground checked remote wire fuses are good im pretty new to this so i barely know the basics

i got a question about a rockford fosgate amp so..... i got a fi bl 12'' and had it hooked up to a planet audio rxd1000 and it worked fine but was really underpowered just got mt new amp in today , a rockford fosgate r1000-1d and my sub isnt working now i checked everything from remote wire, to fuses, to how i wired the sub and i cant find out why it isnt working any ideas please?

i got a question about a fi sub i got a bl 12'' and had it hooked up to a planet audio rxd1000 and it worked fine but was really underpowered just got mt new amp in today , a rockford fosgate r1000-1d and my sub isnt working now i checked everything from remote wire, to fuses, to how i wired the sub and i cant find out why it isnt working any ideas please

lil wayne - dick pleaser T.I. - turn my beat down lil jon and the eastside boys - da blow dead prez - mind sex gorilla zoe - waddle, do it, im dumb, echo ray cash- sex appeal 8 ball and MJG - dont make me kill