blunt

ported at 33hz.

Cool thanks. Based on having two subs that are 800rms each and an amp that provides 1500 will the subs clip if the gain is all the way open?

Is the amp remote a gain remote on the Sundowns? I'm running Fi SSD12s (2) 800 RMS off of the 1500D V.2. If I turn the gain all the way up will they clip?

bump. is this correct?

It's 4V.

Hey guys quick question: I understand this: Voltage of the output = sqrt(RMS Power X impedance of the speaker) Example Say the amp provides 100WRMS into a 4 ohm speaker: Voltage = sqrt(100W X 4 ohms) Voltage = sqrt(400W*ohms) Voltage = 20V So I have a 1500W amp and two dual 1 SSD12s. Would it be? Voltage = sqrt(1500W x 1 ohm) Voltage = sqrt(1500W*ohms) Voltage = 38.7V Should I use 30HZ, 50HZ, or 100HZ tone?

Nice Chuck Norris is THE MAN.

Thanks man. It was a while in the making. I'm pretty much done just need to tweak some things. Got to change the positioning of the head unit so it fits better. Also need to take out the amp rack and sand it and paint it black so it's not just plain wood in there.

Just hooked up the box: Tossed in the trunk: This thing is huge.

Got some nice terminals. Another picture of the way the amp is mounted: I ran the wires: I installed an in-line fuse (175 amp) and mounted on the outside of my fusebox: So I have everything mocked up and ready to go. Just have to connect everything and toss my subs/enclosure in the trunk and I'm ready to go. After all that I decided to install my head/unit. I had to get rid of the supporting humps for the stock radio. It was a bitch to do so. But got it done. The finished product:

Updates guys, got a lot done today. Uploading pictures as we speak.

So I ran into some problems. I got the head/unit in: but there is a problem, it doesn't slide all the way to the back: There is plastic that blocks it from sliding back. Should I cut out the plastic???

Ok so guys, got a question bout wiring my h/u to the wiring harness that connects to the car. The H/u has a ground wire that has a terminal on it to screw it to a spot on the chassis. The wiring harness says to connect it's ground wire to the ground wire of the h/u. Do I remove the terminal and connect the two of them?

Just got some stuff at work including h/u, dash kit, wiring harness, 15ft rca cables, in-line fuse, and holder. Pics when I get home.

Nice. I want to get out and do some dirtbiking. I have a street bike currently and been riding for quite sometime.