SteveCasbeer
-
Content Count
102 -
Joined
-
Last visited
Image Comments posted by SteveCasbeer
-
-
Tweeter with the pillar cover on. I was happy with how nice they actually fit in there. Plenty of room.
0 -
Polk Audio Tweeter to the component set in the stock location.
0 -
Tweeter with the pillar cover and tweeter cover. As you can see my fingers were dirty when i put that stuff on.
0 -
Good old Ipod in the top compartment. I drilled a hold in the front of that to feed the USB cable through.
0 -
Rattle Trap Extreme installed on the inside of the door. Gota finish the rest as you can see. Not a bad pic. of the good old Polk Audio Component MM6501s.
0 -
What you see here is the setting from my Alpine PXA-H100 (Audio Processor). I will have pics of that installed shortly and will explain more about that.
0 -
Some extra Rattle Trap on the trunk lid. I will be painting it to match.
0 -
Polk Audio MM651 mounted with the crossover.
0 -
Subs: Two JL Audio 12" W6v2s
Amp: Polk Audio PA500.4
Amp: Orion 600D Mono (under-powering the JL's, new amp to come)
0 -
Front speaker spacers for the front doors. 1" think MDF unpainted/sealed.
0 -
Speaker spacer installed and painted. Not bad. (left door)
0 -
New spacer installed on the right door. Much better!
0 -
Right door with the crappy plastic spacers I was using.
0 -
Overall pic. Ipod is in the top compartment nice and hidden. Below is the Alpine IDA-X100 Media Receiver for the ipod.
0 -
This is a picture of the Alpine PXA-H100 Audio Processor all tucked away with easy access to the connections by removing a simple plastic bezel piece.
0 -
Microphone connected to the PXA-H100 as well as the cable to my laptop.
0 -
Stinger battery terminal w/voltage readout (thats 12.3 not 2.3v haha). Also the stinger 80a breaker. No more blown fuses just reset it and were back in action. Quite the shitty setup goin there ill admit, but thats long gone and replaced haha.
0 -
Crap plastic spacers again. Big difference. By using the 1" thick MDF spacers it moved the speaker closer to the speaker grill on the door panel. Overall I can tell it sounds nicer also.
0 -
Me riggin somethin up so I could set the microphone where it needed to be.
0 -
More screen shots of the Imprint software doing its thing.
0 -
Close to being finished with the driver side door. I got some secrets still. Then she will be finished soon.
0 -
In this picture you see two representations of frequency response. The top line is the frequency response of my Nissan Sentra. The bottom line are the corrections made.
0 -
On the right is a picture of the Audio Processor. I know you couldn't see it well being installed where it is in the car. On the left it just the software and the microphone. Those were two separate kits I had to buy. They didnt come together
0 -
Getting close to being done. Project this time was upgrading all factory grounds with the 0/1 Gauge wire. Also running the 1/0 Gauge from the alternator the the positive of the battery.
0
222634_575399124102_72106213_32053047_6330251_s.jpg
in Members Gallery
1Posted
Size comparison of the wires