Jump to content

stovebolt6

Members
 View Profile  See their activity

  • Content Count

    280

  • Joined

  • Last visited

Posts posted by stovebolt6

  3. Posted · Edited by stovebolt6

    We discovered this at my house. I could. Not get over how soft it got from the heat. Obviously it was a defective batch. But that is not the point. What we have here is an owner not willing to stand behind his product.

    0

  5. Posted

    I am currently using them, and they d efinitely help big time.

    08 rav4 with three hc2400's a jbl crown 6000gti which is 80lbs about. A large enclosure with two 18's. Car is shy only one inch from original ride height with Max recommended pressure in springs.

    0

  12. Posted

    i have run them alot, and still have a 12", and a few 15"

    if you really want to get them moving they need about 1500rms each.

    and on the extreme side i have ran over 2krms each .

    good driver, just make sure your sub sonic filter is set right otherwise the surround will start cracking.

    box requirments is average to large depending on the power available.

    out of all the 3hp varations i like that one the most. subsquent varations were tweaked for higher bl.

    0

  13. Posted

    I did get some sketches done of our proprietary 18" frame... which will be the very last one done likely towards the middle of 2013. The frame itself measures about 10.5" deep and supports 6" of p-p excursion. That is all the details on it for now =) Expect some more information on the 10/12/15 models in the next month or so.

    i just had a small crisis when i read that.

    0

  15. Posted

    well made a little of progress, not as much as i prefer, but work has been a little busy.

    this is my amp, and battery rack, the bottom board will hold all the batteries, and all thread standoffs will support the second level for the amps. the second level is not done, once o make all the holes and such i will carpet it also.

    this will all fit in the recessed cargo area in the rear. the top board fits the contour tightly and the height from the cover for the recessed cargo hold is tight, so if heat it an issue i already have figured out how i will make a negative pressure cross flow, using an intake on one side. and a row of fans to create the suction.

    IMG_1467.jpg

    IMG_1468.jpg

    IMG_1469.jpg

    0

  24. Posted

    Nice ride.

    thanks. are you going too sbn? its kind of a far drive for you.

    if you are going i will be there, and should have the new power, and my 4hp based 15's i built back installed for the show.

    0

  25. Posted

    Staying above 140 with lows like that on the winshield

    Not bad man

    One question..

    Were you using a subwoofer as a passive radiator? Kinda confused as to when read the passive settup thing..

    in that photo is two tc sounds passives, with one active sub. the sub pictured is a creative sound solutions subduction sdx 15. uses xbl^2.

    and sometimes i would swap the sdx out for other 15's i had, but the two tc sounds variable mass passives would stay.

    just to make sure everyone was on the same page with the passive setup on 1200rms my best score sealed on windshield was 140.1, at 30hz the passives were tuned at 26hz, would watch a lot of movies, so i kept it tuned low.

    my other score was on a saz2000d with a normal ported box, using a 8" aero port, and the two eclipse ti's.

    sorry for any confusion.

    0
×