usacoustics

Hope to see everyone at Slamology 2017 Stop by our booth and say hello

New 12" Subs will be ready for shipping by July 1 2016. Features: Diameter: 12" 300mm Basket: die cast aluminum Cone: non pressed paper cone with high foam surround Voice coil: 4" 4layers with winding height 60mm CCAW flat wire Magnet: 3*100OZ φ220*20mm triple tacked Nominal impedence: dual 2ohms RMS power handing: 1500w

A D4 12" version and a 15" D2 and D4 are in the works and will be out later this year

I have attached a data sheet for enclosure spec's BRAD US 12inch.pdf

Subs are in stock and ready to ship! http://store.soundsolutionsaudio.com/products/us-acoustics-cw12d2.html

We will have all the enclosure spec's on SSA soon

US Acoustics will be at Slamology 2016 June 11-12! Come by our booth and say hello.

from left to right, Big Ben, Nick, Mike, Barbara Ann and Lisa

Here are a few more pictures. They should be up on SSA soon. Will retail for $389.00 I will keep you posted.

Thank you to everyone who stopped by at Slamology 2016 in Indianapolis. We saw many old friends and made more new ones. We also had a few throwback amps on display from the 90's. Good to see Mark and Josh from SSA there as well. Although the weather was almost as hot as the cars, it looked like everyone had a good time. We'll see everyone in 2017. Watch for us coming to an event near you.

Check out the new review on the Mike Mono block amp. Thanks Justin Rock On!

Yes Jerry, just send me your e-mail address US Acoustics

Big Ben and Nick are now in stock! US Acoustics

You are correct, the proper fuse rating is 300A, By the way, Big Ben and Nick are now in stock US Acoustics

send me an e-mail with your address and I will send you stickers usacousticsca@sbcglobal.net

Big Ben (3500 Watts RMS) and Nick (2500 Watts RMS) will be in stock the first week of July Please check the US Acoustics Facebook and Website for some video and photo's

Both are correct but this is really a misprint in the manual We rate the amp at 350 watts continious into 4 ohm using a 1kHz sine wave, but when playing music there is always some headroom as the average current is lower. So the amp will get close to 400 watts depending on the duty cycle. But as you stated, you would not hear the diference. By the way, I have an small istallation to a 1992 Jeep Wrangler converted to a Jurassic Park Replica using a Barbara Ann tp power 2 MB Quart Tower spakers mounted on the roll bar and a 10" Bass tube. I will post some pictures later Nick and Big Ben are comming soon! We will keep you posted Michael US Acoustics