dblovah51

These subs sounds amazing had them on a sq1200 for a few days and was amazed with the low end response. 7.6cb 120sq port

my boy about to run 14v set up n couldnt find info for the 1100.4

he is trying to also do well on the meter for the trunk class category so tuning that low may make metering decent a bit more difficult to achieve, although i know tuning that sucka like you guys said at 30hz will be a pretty nice groundpounder.

Thanks, no problem will do

About to do a build for a 15" evil to ran by a AQ3500 I'm thinking about 4cubes and 65sq of port at 34-35hz. What's you guys take on that open to better suggestions.

i figured they would dropped in because the baskets are the same as, but was unsure of what happens in the gap. but thanks for the response.

no one?

hi i wanted to know if there is a downside to using an N2 recone on a ufo btl, because i have a friend with 2 recones and have no use for them and i needed recone. would they work?

They told me to contact demetric bond in NC to repair our 14k that's about 3 days old smh but so skeptical about where to send it because I've seen bad experience in repairs to a 11k those amps are PIA.

That's exactly what am sayin knowin that ppl run that as low as .25..but the coils are good the subs are BRAND NEW mayhem and each coils are readin the same,, a guy who repairs them said it could b a chip that's stuck so he ordered one to try that.

sure have no problem tryin it, but what's ur opinion if it stil does it at 4ohm which ill wire it to?

No we haven't even considering it bein that it won't b playing it at that ohm load

Was hopin someone like jefferson for stetsom would chime in...

Even when we connect a dual 2 mayhem to it it still protects as u begin to gain on the amp.

I think the amp was bein played on a low voltage battery bank and had no volt meter to identify the batteries was drained by a dead one, that caused the first failure.