Search the Community
Showing results for tags 'fabrication'.
Found 2 results
I searched the forum for any previous posts and information on this and came up empty handed so I apologize if this has been covered before. I finally talked to my buddy about the fiberglass stuff he was talking about that came ready to go, all you had to do was mold it around whatever it was you were using it on and let it cure. I found out that it actually cures in sunlight, or under UV light and has a wire mesh in it to help it hold it's shape. It's not horribly expensive either. I found 1 sq.ft. pieces for $24 at Jeg's of all places which I didn't think was too unreasonable considering it's got everything a person needs to make it work. I would imagine that by the time a person bought enough resin, hardener, molding supplies, glass mat, etc. to do the little sail panel pods I'm wanting to do that it would cost more than $48. Maybe not, but for the location and shape these are going to have to have at least doing the main part of the pod would likely be easier with the Hyperfiber. This is a subject I know VERY little about so some insight and help would be greatly appreciated by anyone who has fiberglass experience and especially experience with this product.
I would like help with a design of a box for a Sundown Audio SA 12" sub woofer , that is 12" at the bottom, 8" at the top 17" tall and 30" long, with the sub woofer mounted on the slanted side. I would like it to be ported, and tuned to 32 HZ. Again, 3/4" MDF 12" bottom 8" top 17" tall 30" long Tuned to 32 HZ Sub-woofer mounted on slanted side Truck-box style.