RL-P 15 D2 Box design

[rog2961 0]

I got these two box designs off Ca.com, im just wondering if they will be fine. Will be powered off a nine.1 1200w@1ohm with the gains turned down a little bit. Running a 15 rlp

http://img30.imageshack.us/my.php?image=35...z465sqin0cb.png

This one is 3.5 cubes tuned to 30hz

http://img30.imageshack.us/my.php?image=32...z435sqin9pz.png

This one is 3.2 cubes tuned to 28hz.

Im leaning more towards the 3.2 cubes as I want to have SOME space left in my trunk. Would these two box designs be sufficient or should I go with tomsething else.

[Aaron Clinton 2,372]

The 3.2 should be fine. But installs vary from car to car. So the best thing would be to try it out and if you feel it is too big you can add wood slugs to the inside of the box to reduce air space.

[rog2961 0]

hrmmm would bigger be better in the case of the RL-p15? Boxwise that is.

[Parker 2]

the size difference in the boxes will be minimal I'd go ahead and run the 3.5 with like 60 square inches of port

[rog2961 0]

anyone know of a box design that i could use for a 3.5 @ 28hz. Been lookin around and i can't find any. Plus this thing doesnt model well in WinISD

[tez4life 1]

3.5@ 28hz is nice. Im currently running 4.0@ 28hz and it sounds good. Hits upper frequencies well and digs low very well. 32hz would be a better tune IMO if your looking for a lil more output, but 28hz will give it to you as well.