Jump to content
alexgammer1

wiring amp to bl 18"?

Recommended Posts

ok i'm using a rockford 2 channel amp running about 1200 rms. The amp isn't 1 ohm stable so, when i wire up the sub to put a 4 ohm load into the amp will i put the postive and negatives into the amp where is says bridged? Also i was wondering what i should tune the amp too? My box is tuned at 33hz and i have the p chamfer BL 18". I heard i should set the gain at .5 but that doesnt sound right? i dont know if you need the name of the amp or not i'll have to check for the name and edit this. thank you

edit- BL18" dual two ohm. just with p chamfer

Edited by alexgammer1

Share this post


Link to post
Share on other sites

×