Jump to content
Sign in to follow this  
dbsupra

measuring port length for slot port 90 degree bend

Recommended Posts

Starting a new box build this weekend. I'm doing a slot port for this one.

The box is 23" long with a 2.25" wide port. Need a 27" long port to tune.

According to my math, the L section of the port needs to be 4" long.

This assumes 2.25" from end of box to edge of long port length which I come up with 20.75. Taking center of port at 21.875 that leaves me with an L of 5.125 center. Subtracting back in 1.125 of center leaves me with 4".

For end correction, I need to add back in 1.125 which brings me back to 5.125" L

I've had a long week. Is my math correct? I don't design a lot of slot ports.

Thanks!

Dave

Share this post


Link to post
Share on other sites

just measure the length down the center of the port.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×