what size wire do i use?

[Briggiboy33 2]

The amp im buying says it takes 4 guage... but its a 1600rms amp. I also have a amp on my door speakers that takes 8 guage but do i run a 1 guage and a distribution? Or do i go bigger and try to cram bigger than 4 in the sub amp?

[Sencheezy 689]

You could run a 1/0 cable from battery to a D-block, and then place accordingly. You could run one 1/0 cable from battery, to a 1/0 to 4 gauge reducer, and then run a 8 gauge from battery to your mids/high amp.

[mickey95 0]

the bigger the wire size you can fit the better

[bassahaulic 155]

What amp is it?

[SPL_Man 20]

get a fuse block like this stinger shd820 which has 1 0g in 2 4g out block like this , there should be a 8g reducer ring in it too

http://www.stingerelectronics.com/productDetails.aspx?ProductId=574&CategoryID=13

Edited May 14, 2012 by SPL_Man

[bassahaulic 155]

Or, snag you up a small battery for the rear and distribute off of that!

[Briggiboy33 2]

Its a soundstream rubicon 1600d on the ssd15. And my first amp i ever bought a pyramid classic on the front doors. Lol. But it works fine aslong as its not turned up too high... but so i should get a 1/0 power and distributer block. Alright thanks guys!

[bassahaulic 155]

I like the battery idea!

[Briggiboy33 2]

Lol no room in an access cab tundra with only one less seat...

[Briggiboy33 2]

Lol and btw there is absolutly no possible way im going to spend 60 on a distro block... but ill get a cheap one on amazon