Polyester Filtering Capacitor Help

[Jason Witt 65]

I need to replace four of these, but cannot figure out the vales to find the part. Help?

 

 

[altoncustomtech 773]

Is that the only information available on the part?

[Jason Witt 65]

Is that the only information available on the part?

Yes, I cannot determine how to calculate the values because of the limited information. I know what type it is, and what it does, just can't replace until I find the right ones.

[Jason Witt 65]

[///M5 2,833]

?? http://www.digikey.com/us/en/ph/Epcos/B3279X_series.html

[Jason Witt 65]

?? http://www.digikey.com/us/en/ph/Epcos/B3279X_series.html

I saw those, but the prongs are wrong on the bottom side.

[///M5 2,833]

?? http://www.digikey.com/us/en/ph/Epcos/B3279X_series.html

I saw those, but the prongs are wrong on the bottom side.

Good luck getting a chinese part in the US. Some custom fab is probably a likelihood. Are any of them good?

[Jason Witt 65]

 

 

?? http://www.digikey.com/us/en/ph/Epcos/B3279X_series.html

I saw those, but the prongs are wrong on the bottom side.

 

Good luck getting a chinese part in the US. Some custom fab is probably a likelihood. Are any of them good?

 

Three are good, but I want to change all four to be safe. I did some more research and the prongs are fine. I just don't know the capacitance rating. 

[kirill007 52]

10UF(:microfarad) with a tolerance of 10%.

[nem 2,019]

If all else fail call

 

http://www.newark.com/

[Jason Witt 65]

Thank you guys. Now I can get it fixed.

[Jason Witt 65]

10UF(:microfarad) with a tolerance of 10%.

Would an 8 UF work?

[Jason Witt 65]

Found some exact caps. Thanks for the help.