Jump to content
Sign in to follow this  
Mr.jaundurfle

IA 3.4 at 8 Ohms?

Recommended Posts

I am thinking about running a set of Peerless SLS 8" mid bass drivers on my IA 3.4 amp. The Peerless SLS's are 8 ohms, so if I were to run the 3.4 bridged would I get around 110 watts per channel for an 8 ohm load?

Share this post


Link to post
Share on other sites
lithium    322

yep something like that. i run mine on about that much. more than enough power to rattle your doors to pieces. 

Share this post


Link to post
Share on other sites
SacredTanakh    67

I am thinking about running a set of Peerless SLS 8" mid bass drivers on my IA 3.4 amp. The Peerless SLS's are 8 ohms, so if I were to run the 3.4 bridged would I get around 110 watts per channel for an 8 ohm load?

8ohms is the way to go, and that should be plenty. On most active setups you don't need a ton of power. I noticed with my neo pro 10s crossed over at 80hz and 4khz I got only a small boost in output and clarity when switching from 180w each to 600w each. They take it like a champ suprisingly enough too wink.png

Edited by SacredTanakh

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Recently Browsing

    No registered users viewing this page.

×