Jump to content
Sign in to follow this  
vetkilr

Any news on the MD3 Yet?

Recommended Posts

still doesnt fill the dang heat sink

I was just thinking that, not sure why

jr, if you read this reply, is it because of a standard heatsink or OEM board?

anyway the internals looks monsterous!! would love to try it heads up against my orion

It's is due to the amplifier needing surface area to cool efficiently and for faster assembly. Unlike the XT and AX which have bulk of aluminum on each side for transistor mounting the MD uses top surface area for transistor mounting.

:thanx:

Share this post


Link to post
Share on other sites
If the amp isnt rated or .5ohms they wont have .5ohm numbers

Greg was gonna put it on and test it at .5 wanted to know if any .6 numbers were out yet.....guess Ill call :coolugh:

Share this post


Link to post
Share on other sites

Greg told me they do not like .5 ohms (actual load). But with a .5 load (like a dual 1 ohm sub), they are ok with impedance rise. So just plan on rolling the volume vs. burping them if you are going to run them that low.

Brian

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×