-
Recently Browsing 0 members
No registered users viewing this page.
-
Similar Content
-
By Travis
Well bad news. Was about to order the second level 6 18 but apparently all the m4 motors are gone. Theve just released the m5 motor. Soo it was all up in the air over either some sp4v2's or new btl neo's. Tried contacting FI three separate times over the past few months with no response. Thus it looks like I shall order a pair of evils in the next couple weeks. I'm not bashing. But I've seen the service ssa provides. And that's the service I'd like to get as a paying customer. God knows this isn't a cheap hobby.
-
By Omega_Ace
I am looking to get a 15"or 18" to go into a sealed box for sq. Leaning towards the 15" at the moment.
Car: 98 Mustang
Location: Trunk
Amp: MTX te1501d (birthsheet @ 1 ohm is 1556 rms @ 13.8 volts)
Wires: 0 gauge on big 3, main battery to second battery in trunk, & from second battery to sub amp. 4 gauge to highs/mid amp from second battery.
Stock 130a alt. but I'm getting a 270 Mechman and xs 3100d( will be under rear seat) when i order the sub or shortly after.
If i go with the 15 the box will be 26.5L x 26.5D x 11H about 3.5 cubes before displacement. Sub will be upward firing. I'm tossing up the idea of the 18" but don't have experience with 18's. Any idea's if the 18 would be with the trouble?
Thanks in advance
Also the reason for upgrade is because my 12" mtx thunder 9500 @2 ohm just isn't enough anymore
-
By disturbeddrummer254
I am planing on getting SSA 2 Zcon 18's and a Crescendo 3500d next week. I have a 98' GMC ext cab truck. What type of set up is best in my vehicle? wall? ported box with subs up? subs forward?... need some advice..
-
By EPerez
I just ordered my zcon 12s. I am really happy and can't wait to have them at my door. I'm going to tune around 30hz off of 2 nendo bc2000s. I'm ready for a serious ground pounder. Thanks SSA!
-
-
Recent YouTube Posts