Jump to content
Sign in to follow this  
dylan12321

Question about crossover points and EQ

Recommended Posts

I recently put a system in my regular cab Silverado, and i am wondering about where to start (general range) for crossover points. I have 2 sundown sd3 10s running off of an NVX1200.1 and a set of SSA Evil 6.5s and Tweeters running off of an NVX 800.4. It is running active off of a pioneer 80prs. Also, is there a general place to start as far as slopes go? 12db or 24db? I know every install is different and people have different tastes but im just looking for a decent place to start from. 

Share this post


Link to post
Share on other sites

Find the limits of every driver in every position and then go from there.  I would start with a place right above where the tweeters break up at reference levels and then blend the mids to match.

Share this post


Link to post
Share on other sites
4 hours ago, ///M5 said:

Find the limits of every driver in every position and then go from there.  I would start with a place right above where the tweeters break up at reference levels and then blend the mids to match.

I think i have a decent setup now. These SSA mids and tweeters are pretty crazy. Super loud and clear. I had to dial the tweets down a little.

Share this post


Link to post
Share on other sites

Don't stop experimenting, just make sure you baseline them alone so you don't go too far.  Much easier to hear stress ONE driver at a time.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×