Argent Audio

Ok here is what I came up with: 22 deep 16.5 tall 31.25 wide 3.75 @ 33HZ Double baffle Andrew

10's will be possible!! 22 deep 15 tall 24.5 wide If you want I can move the height down to 14 since we have plenty of room to play around with width wise. Andrew

3HP has a thin top plate for such a large motor which can be an issue at times... Andrew

PVC elbows are WAY different. ABS is a much thinner plastic. ABS servers a very different use compared to PVC in the construction world which makes them nothing alike. You want the end of the port at least the diameter of the port away from the insipid wall of the box. Andrew

Ok so just a standard ported enclosure. I put the terminals on the side anyway so your good to go there Also I'm assuming you have a 12 inch Xcon? Andrew

I want to make sure I understand this correctly, are you just going to fold your back seats down and fire the box into the car? Andrew

Lawl at the vid, your poor car. Andrew

I did up the other style and it took up just as much room because the port is so long. So if I could just get your paypal email address I will send you over an invoice. You can send it to me in a PM. Andrew

From now on I will post here when my next live session will be!!! Next Live Show: NOW!! COME WATCH!!! Andrew

PM me your paypal email address and I will send over the invoice. Andrew

Bump, building live!!!

Streaming live right now of some enclosure building!!!! Andrew

how much will shippping be? Rough quote is $50. UPS has had rate increases every week for the last month due to the hike in fuel prices so it's hard to say how long that $50 estimate will be good for. Andrew

I was not able to shave much off because of how long the port need to be. I could switch it up to a labyrinth style port which would move the mounting location of the subs to the far right side of the box. Doing it that way might be able to get another 4-5 inches off the width. New Dimensions: 12 deep 12.5 tall 33.5 wide Let me know what you want. Andrew

If you can just send 25% right now which is only $38.75 I can get it started so that why it will be 100% done by the time you move. Are you able to do that? Andrew

After messing around with all the different design possibilities a Kerfed port is not possible either. The port is going to have to be 4 inches which so it takes up too much of the width to fit the large radius of the Kerf. If you are looking for more output I would suggest going with a high RMS sub such as a Xcon and the pairing it with a SAZ 1500D. Andrew

Due to the small height flush mount will not be possible on this enclosure so I will design with double baffle in mind though. Andrew

Ok here is what I have: 14 deep 15.75 32.25 wide Flush mount 2.0 cubes @ 32Hz Andrew

I would go with a simple enclosure. Sub back, port back. Put the box on the left side of your cargo area, with the port on the left side of the box and you will be golden! I will work on a design right now. Andrew

Here ya go!!! 11.75 tall 12 deep 34.25 wide 1.2 cubes @ 33 Hz Flush mount Let me know if you want to mess with any of the dimensions. We could easily add some to the depth or height to take away from how wide it is. Andrew

Thanks Andrew

Second version of this box. I broke the first one apart so this is the rebuild Andrew

Sorry for the delay. Assuming the shipping weight is 70 lbs which I guessed pretty high. I'm hoping the box should only be about 40. 70 lbs shipping cost is about $100. If this is ok I will get a design started. Andrew

Just send me a PM with your paypal email and how many you want and I will send out an invoice. Andrew

Ok, sounds good! Just keep me posted. Andrew