southwow
-
Content Count
6 -
Joined
-
Last visited
Posts posted by southwow
-
-
I think I've answered my own question. The manual is probably describing individual speaker impedence rather than total impedence (hence the 2-ohm minimum). This would mean that the two 'channels' are really just wired in parallel internally, meaning that diagram #2 on page 7 of the manual is the correct way to wire 2 subs in parallel.
0 -
Sorry for such a stupid question, but the owners manual isn't really specific about 1-ohm load with 2 subs.
I have two infinity 100.9's (10" SVC, selectable 2 or ~4 -ohm impedence, obviously set to 2-ohm). I want to run a 1-ohm load on a SAZ 1000D.
My question is, how do I wire them?
Do I wire one to each set of speaker terminals and yield a 1-ohm load or will this yield 2-ohm? This is shown in the 2nd diagram on page 7 of sundown manual.
... or ...
Do I need to wire them in parallel as shown being done with only 1 sub in the top/1st diagram on page 7 of the sundown manual, a method of wiring that I've NEVER seen before on a mono amp?
If this were an old-school HCCA amp, I'd know the answer... with Class D stuff and the sundown brand, I'm not so sure.
Thanks for any help!
0 -
I'm guessing that you need 3 posts in your count to post in the real forum...
0 -
just wondering
Word of mouth, you guys come highly recommended!
0 -
Hello,
I'm the proud owner of the following...
SAZ1000D
SAX50.4
I've been out of car audio for a while... actually about 10 years. I've heard nothing but good things about sundown, hopefully the class D amps will live up to the old 1st and 2nd gen HCCA class A stuff I'm used to!
0
SAZ 1000D sub wiring question
in Technical Info & How To's
Posted
Thanks for the help everyone!