antonmiller

is there any other place but AudioQue's website to buy the amp? and what about the aq 2200? would that work well if i set the gain to around 1500 rms.

how do you know if its doing rated power? the amp i have now says it does 1200 rms at 1 ohm but i dont think it does that. i was looking at the AQ 1200 and it looks like a good amp. but i dont want to pay for it if i dont know its an upgrade..

yea i know about the hz being off it was just a typo because i had that in the notes for the previous box design. but i did construct it and put my fubar in it for now and it sounds great i cant wait to put a Bl in there. Thanks for all your help. Anton Miller

I'm in need of some help on a box build. I'm planning on getting 1(one) fully loaded FI BL 12" dual 2ohm. I would like to know what size and type of port to use, I would like a slot port (not sure what its called) tuned at the recommended 32 hz. If some one could get me some ideas on the size of port to use and that sort of stuff(i have no clue how to make a good port). I have a 3d cad package (SolidWorks 2007) to were I can design it my self I just have no clue what size and type of port to use, or how to use it. The set up is going in a Chevy Cavalier 2 door (rear seat does fold down, not sure if its relivent) and the amp I'm using is a Power Acoustik BAMF 2000/D (runs 1200 rms at 1 ohm). The maximum width for the trunk is 36" and the height is 17". I will post up a concept in a little while for the style of box I want. Also I can post up prints for the "cut sheet" as well. All help is appreciated Thanks, Anton Miller

New PDF this is a new design that i was suggested to go with thru a different source. If there is anyone out there that has looked at this and has something to say please do speak up i want to be 100% prepared for this box build. Thank you, Anton Miller

Ok, I used both programs and I got about the same results and here they are on the DWG. I was just wondering if some one could look it over and see if this is a good box for the bl 12. PDF OF DRAWING Again thanks for all your help! Anton Miller

This is my idea... not sure if its good one