whitesharingan

So I put the glue down, set the spider & surround down then spray the accelerater on the glue surrounding the two? Or put the glue down, spray the accelerater on the glue, then set the spider & surround?

There was no instructions for the adheisive kit that fi sent. There's a spray & what I think is the actual adheisive.

I've found youtube videos, but there was no instructions with the adheisive kit. It comes with a spray & what I think is the actual adheisive.

I've never done a recone before, and I was wondering if there's instructions on exactly what needs to be done. And how to use the adheisive kit that comes from the website. Thanks for any help.

click on the (MX-3) it's a link to the page with info.

But I have this in line (MX-3) So I match the h/u's voltage to the sub. input of this unit. Then my question is do I match the output voltage of the MX-3 to the signal voltage rating on my amp?

My amp has a signal voltage adjustment range of 150mV - 5V (RCA Input). And my question is do I set the sub. output level from the MX-3 Bass controller to 5V? If it helps I have a RF T2500-1bd amp. Thanks for any response.

So in my case, will having the amps built in 28Hz 12dB/octave SSF combined with a F-Mod SSF with a 30Hz value @ 12dB/octave, attached in line, make everything perfect with a box tuned to 30Hz?

When you do let me know and I'll be happy to pick one up.

BUMP. I know that there is only a little amount of time set aside to do recones. I would just like to know when my sub might be shipped out. Again if I could get a Mod. or somebody from the recone department to reply to this that will be great. Thanks.

I assume that you are referring to the F-mod SSF found Here with the 30Hz value. Also are you saying that the SSF should have a 18dB/octave, because the one here only has a 12dB/octave.

1:Is there a difference between these two? 2: Does the filter have to match the boxes tuning? Or is there an acceptable range? I have the RF T-2500.1BD amp with a 28Hz infrasonic filter. 3: If I use a box that is tuned at 32Hz, will this be sufficient? 4: If not where can I find a good subsonic filter? Thank you for any answers or suggestions.

Hello I sent in my 12" BTL to get re-coned, and I haven't received any word on when it will be returned. I sent a couple of E-mails over a week ago and haven't got a response from the re-cone department. My Order#I-15761/00. If a Mod. can get back to me as soon as possible that will be great. Thank you.

When are you guys going to be open & ready for business?

Woot. I don't mind the wait for 20% off.