Quentin Jarrell

Yep and PM'd me to remove info from his threads. Seems to me he's just interested in promoting his you tube channel rather than informing the site.

Imagine this as a panel and u got urself a mini grave digger. It's a bit over ur budget though.

By outputs you mean RCA output then it's just an internal y splitter to send signal to another amp.

Their specs are so close you wouldn't notice a difference.

The cheapest route would be to attach a PAC SNI-15 to your speaker outputs on the headunit and use y adapters at the high amp. Or use two PAC SNI-15's and run two sets of rca's to your amp.

This was 4th order bandpass for two 12's. (4th order has to do with roll off, not a type of enclosure). Customer seemed to be happy

This was 4th order bandpass for two 12's. (4th order has to do with roll off, not a type of enclosure). Customer seemed to be happy

Get the pioneer unit or and Audiovox piece.

This is the same piece after a light sanding preped for primer. Only about two tablespoons of filler was applied to the entire piece.

There is a right and wrong way to lay fiberglass. You don't see boats made from lots of torn up pieces. You must wet out the mat before applying it. This pie e for example is 3 layers of mat. No filler just a light spray of cabosil.

IAs he already knows it'll be much cheaper to stay with a gm product.

Hard to beat an old chevy. I've got a 46' pickup with a 383 and 1.6L whipple.

I've always liked 40's 50's panel trucks.

Same car?

Those gauges must be adjusted. However newer gm and dodges idle that high. Higher voltage, more spark, less fuel needed, better fuel economy.

Before you add your fleece if you run a 1/4" rabbet around your panels it'll make for a stronger bond and it'll allow you to keep the glass off of the top of your window area. That way you don't ruin the nice routing and it'll make it quicker to finish by minimizing filler. Never mind saw the rabbet in above pics. Guess you just haven't trimmed the fleece in the pics yet. By the way if you haven't gotten to the glass yet, use one solid piece instead of tearing your matt into pieces. It'll make it stronger and smoother. If your top layer is 1/2 ounce Matt topped with surface veil you should only need less than 1/2 cup of body filler to get that panel ready to wrap or paint.

They gonna have to do Lay A Way specials.

I've got SpeaD and can measure Kms in the working range. . I can get within a few percent of small signal T/S

You need dual one's? I might be able to hook you up if I had some measurements.

I've built a box or two in my day.

Looks like about 40hz tuning?

Haven't seen a warhorse in a while

Like I said before. Do not use the image function on the reply. Just copy and paste like you did with the http. But copy the IMG off photobucket. Instead of the http.