liljestrand

Sorry I havent been around. I have 0 45's in my box atm. I am actually in the process of building a new box and getting new amps. I built that box based on what someone had told me to without running the numbers on the box...basically it came out to like 10 cf with 20 sq in of port per cube tuned to almost 50. Needless to say it was no where near optimal. The new box should be more in line with what the subs need. 14 cf with 14.5 sq in port per cube tuned to 38. and honestly Im not that hard to find on facebook as there are not many liljestrands.

From what i was told

yeah we needed that lift bad. 480lbs in subs alone plus around 200 in wood. it was fun enough having to lift it up onto the lift to slide it around.

its open on the backside so i can easily run wires out

but before cutting anywhere around back there be extremely careful as the gas tank is awefully close to that spot...I had a friend drill through his trying to do this same thing

the back seat. if i would have looked better underneath i could have picked a better spot. I think i went through a body mount there.

Made a center console for the rear buckets to house the batteries. Also has a cupholder and a usb/lighter plug in. B2 hn6 pa mids and id horns.

Iirc the zcon doesn't have a pole vent. So you should be perfectly fine.

The sub was above the port wall. I could barely fit a finger underneath the motor. Thus the vent hole was covered up pretty good. To allow for better cooling I moved those subs back so there is a good 5 inches or so behind the motor

Like Jay cee said I'll help out here as much aS I can

What do you want to know.

working on the cooling fans making a platform for the amps and a platform to raise the amps up to allow the fans below to breath so with the original baffle we ran into 2 problems, 1 I accidently cut the speaker cut outs a half inch too big and 2 the motors for the front subs was right above the port. So to alleviate that we centered the back 2 subs and moved the front 2 subs back. also we need an engine hoist to get this thing out and thats without subs. thats about all i have for updates. will hopefully be able to get more into this in the coming weeks.

A 110lb sub will give you a hernia? That's cute.

I think it's just above window line Iirc. But it's under 25" which is what I need for suv for iasca

Fairly cheap and easy. Cost about 15 bucks

The rest of the goodies showed up

Some goodies showed up. 3/0 electron beam and some 3/0 lugs. Xspower psc60 intellisupply charger and 4 mechman 370s ordered from ssa.

Ah They are o on the site. Thank you

x2c they are a limited run so they may not be on the site.

A smidgen of an update