Jorgasm

Wow... your up late!!! Thanks ...I think I'll take your advice on the 0 gauge run. Do you know what the input power wire gauge is for the 4000d and the 1600.4 and the fuse ratings for each? Also, I already ordered the 6 farad cap ;( -but I got it for $54.00 so I'll probably go ahead and throw it in. Wouldn't hurt, would it? I just hope it's not overkill for that little cab.

Hi guys, new to the forum... just looking for some input from people that are familiar with US Amps and RE Audio. I just dropped some cash for my new system, and was curious about your opinions on my choices. I haven't installed anything yet except the deck as the amps and cap won't be here until next week: 2001 GMC Sierra Stepside - (STANDARD CAB!) Head Unit: Pioneer BT9800 (Bluetooth rocks on this deck!) Subs: 2 RE Audio SE 10 inch (new logo) - will be wired to 1 ohm Enclosure: Custom Built Sealed @ .65 cu ft each (optimum according to RE) - 3\4" MDF (Air tight, trust me!) Sub Amp: US AMPS XT-4000d (2007) Front Doors: Infinity Reference 6.5" Co-axial (Existing, currently running off deck, and plan on upgrading soon) Rear Pillars: Infinity Kappa 4x6 Plate (Existing, currently running off deck, and plan on upgrading soon) Amplifier: US Amps 1600.4 (will be used "CONSERVATIVELY" with the above) Capacitor: 6 Farad Kole Audio Wiring, Fusing, Distribution Blocks, RCA Interconnects, Sound Dampening: Stinger Audio Battery: Upgrading to Optima upon install. Keep in mind, I am more interested in SQ vs. SPL, especially in such a small cab, but I could only afford the XT line. I plan on keeping all my gains low- I want Loud but Clean. I do have a couple of questions though: 1. I am planning on running 4 ga high strand power to the cap and I am now wondering if I should have run 0/1. 2. Will I be ok with the stock alternator 100Amp, considering the Optima Battery, 6 Farad Cap, and doing the "big 3" especially since I am going for SQ? 3. Can someone please tell me the fuse ratings and input power gauge for these 2 amps.