mythyone

Amp is 1 ohm stable. i just retested the coils from the tinsel leads and one reads 2.4 the other is reading 2.2 ohms. I talked with the guy I bought it from and he said that the terms may be rusty and messing up my reading. Im gonna clean them up and see whats going on.

I know its got me confused too. I just didnt know if i ran it like that if it would hurt the amp at all

I just got a 05 RE XXX off someone local and i took a DMM to it and got a weird reading. When wired together it reads 1.5 ohms but seperate one reads 2.0 ohms and the other is sitting @ 4.0 ohms. Would it be bad to run it at the 1.5 ohms? And how does something like that happen?

I was looking for some ppls 2 cents on a set up choice. the setup will be a 12" RE SE in a 3cu ft. box @ 33 hz powerd by a kicker 400.1 Just wondering if this will be a good combo. Its goin in the back of a f-150 by the way. Looking for good lows while not sounding like poop. I have had the sub for a lil bit now but am finaly putting it back in my car, last time it was in a 2cu foot box @ 34hz and only got about 200 rms. Hoping by adding more power and a bigger box it will sound better. Thanks

I need an amp to push 2 12 re se's. I want to give them at least 1k rms @ 1 ohm. I dont realy wanna spend more than 300 either. One amp ive been looking @ is the AQ1200D but im open to other ideas as ive never used anything from audioque. Thanks

Im wondering what sub i should use with a Kicker ZX750.1 . Im gonna be getting the amp with my next check (i hope) and im wondering what sub i should use with it. Im looking for a single sub setup and prefer using a 12". I have a RE SE atm but i was wondering if there is somthing that will do good off this power, 750 rms @ 2ohm. Ill be using ported and have a good amount of space for a box. My budget is around 200 for a sub. I want somthing thats gonna sounds loud to the ear, dont realy care about on the mic (dont think there are many comps around my area anyway). A few subs i was thinking of switching too were Audioque SD2.5 FI SSD no options Kicker L7 Im open to any ideas, thanks

Any thoughts on the Profile 1000 watt mono amp? It says 500rms @ 2ohm and its realy cheap!!

Its dual 4 ohms, and i want to stay around 200 bucks.

Im looking @ getting a amp for my SE and dont know which way to go. Im kinda on a budget but im open to all ideas. Want to feed it as close to 600 rms as i can. off topic: Hi to all, im new here