ALCW5

Oh ok nice ive worked on those as well very similar any other help u need juss let me know bro good luck pm or somethin

To get that metal panel off there is access holes to remove the glass from the regulator one of the wholes it where the speaker goes release it pull it all the way up then tape it it all comes out complete remove three bolts from the door latch and and all the 10 mm i belive they are all around the outside of the metal panel then u should be able to juss menuver it right out to make it easier with the wires plugged to it sneek ur hand in between the door and use a pick to release the harness plug that goes to the car then u could pull it all out and have all the room to do the exterior door skin you may or may not already know this just thought i would try to help if i could good luck man cant wait to see it all deadned

Sorry im kind of new to the forum not really sure how to navigate much especially on my phone and it looks like i may have double posted how can i deleate the second one ? And thanks for tuning in , also any tips on building a wall

So im plannin on building a wall in my crown vic soon. i have a DC Power 270Xp alt plannin on putting 5 batts in the back 2 18" fully loaded Fi Sp4s dual 1 and going to buy a crescendo 5500 along with knuconceptz Wire. will wire subs down to 1ohm together also have 4 crescendo 8" mid range speakers for the doors plannin on a few 6.5s as well super tweets planing to deaden all over using murder mat. Now onto the wall i will be sending max dimensions to BHE soon and get a wall design i am going to be aiming for about 7 if possible 8 cuft per sub tuned to 33hz also was lookin to go for 15 16 on the port vol. sorry if this is a little sloppy im on my phone ill post some pics of stuff if people are interested thank you all in advanced any help will be very much appreciated daily driven ground pounder is wat im aimin for demo friendly

So im plannin on building a wall in my crown vic soon. i have a DC Power 270Xp plannin on putting 5 batts in the back 2 18" fully loaded Fi Sp4s and going to buy a crescendo 5500 along with knuconceptz Wire. will wire subs down to 1ohm together also have 4 crescendo 8" mid range speakers for the doors plannin on a few 6.5s as well super tweets planing to deaden all over using murder mat. Now onto the wall i will be sending max dimensions to BHE soon and get a wall design i am going to be aiming for about 7 if possible 8 cuft per sub tuned to 33hz also was lookin to go for 15 16 on the port vol. sorry if this is a little sloppy im on my phone ill post some pics of stuff if people are interested thank you all in advanced any help will be very much appreciated daily driven ground pounder is wat im aimin for demo friendly