EddieC

HU is a DUAL XHD7714.... nothing special, but has Bluetooth and gets the job done. It does have a sub adjustment to it, which I only use at lower volumes to even out the sound. Amp KAC7005PS specs: 40x4 and 300x1 at 4 ohms 50x4 and 500x1 at 2 ohms variable low pass filter on subwoofer channel (50-200 Hz at 24dB per octave) separate variable high pass filters on f & r channels (50-200 Hz at 12 dB/octave) variable bass boost on sub channel (0-18 dB at 40 Hz) I'm running 2 s4 ohms in parallel to achieve the 2 ohm load for the subs.

Ok... after looking all over the net at different setups in xBs, I think I'm gonna run with the design in the thread I originally listed. I'll just keep the seats down to face it to the rear, and face the box up when I have passengers. Or I may just keep it firing up after seeing all the rides I just checked out, seems to be the go-to in this vehicle. One last question though (not sure if I should post in a different area for this one...if so I'll be happy to move this).... subsonic filter. I'm running a Kenwood 5 channel amp that pushes 500RMS at 2 ohms to the sub channel. It only has low and high pass filters along with a bass boost adjustment. Running 250 to each sub, I'm pretty sure from all I've read that I'll need to add a ssf to keep from damaging them. Am I right? I'm pretty strapped for cash after all the equipment I've added so I'm just looking something relatively inexpensive to get the job done.

Thanks BigGuy.... I hope so. That sounds more within reach!

18" depth is only good to around 10" height..... downhill from there. Looks like a wedge would be my only option. UNLESS..... down firing? Or up?? Had not thought about it, but dimensions may allow for that. But how would that sound?

The prebuilt ones on the site are 4.... optimal per is 2.25. I want to get as close to that as possible while maintaining a 32hz tuning..... if that's possible with the limited space.

Just did.... thanks for the tip. However, the only designs I'm finding have at least a 20" depth. I have the 20" base, yet the angle of the seats limits me to 15" depth by the time 18" of height is reached. Any possibility of a ported wedge design within those specs that anyone knows of?

Ok... this isn't gonna work. Too deep. I'm putting this in the back of a 2004 Scion xB. Looks like I have around 17-18 inches from the seats to the hatch. Looking at the enclosures for sale I see a 20"+ depth, so I may be sol on ported. Looks like it's sealed until I can find a design.

Hey guys. New to the board here so I hope this isn't a played out topic...... but the only design I can find on SSA's site is for a single sub. Is there one floating around somewhere? The only one I could find on the net was here ----> http://www.*****.com/board/topic/158983-need-a-ported-box-design-for-2-12-ssa-dcons/ Is this a good one to try? I noticed all the youtube vids I've seen with 2 the box looks like the single enclosure design, with the port to the far side of the face. Thanks in advance.