Stu55

SWR-1022D, .75 sealed, headunit is a pioneer DEH-P6900UB

How I wired it: http://akamaipix.crutchfield.com/ca/learni..._2-ohm_mono.jpg

My "Infrasonic filter" switch was set to 25hz. The speaker was used, and had been sitting around for awhile...if that helps. It did not seem like the cone was moving too violently according to what I have seen from a type r.

I used super glue and glued it back around, I am waiting a bit and going to see if it works.

Box is .75 sealed. Here is what it looks like (all the way around)

How I wired it: http://akamaipix.crutchfield.com/ca/learni..._2-ohm_mono.jpg

I suppose...any good repair kits for it?

I know this part is not in the correct section but wtf? My type r just blew, this amp says 500 watts rms @ 4 ohms, this sub is supposed to be 500 watts rms but others say it can handle a lot more. what?

lol no, but am I correct? 44.7213595 volts?

I read the sticky but I wanted to make sure I was correct, I have a alpine type r 10" dual 2 ohm sub and a kenwood KAC-9104D amp which is 500 watts rms @ 4 ohms. So is it; Voltage = sqrt(500 watts x 4 ohms) ?

That is a sweet ass truck man!

Is there a visual anywhere out there? Oh, I think I got it now.

Hey this site is pretty awesome, I have a 2000 Blazer LT 4 door and I'm soon to be putting in a Fi SSD10 dual 1 paired with a kicker zx750.1 in a 1.1 cu. ft. box, hope it sounds good...