Wyo

Truly concernedAnd you weren't about the FT1? Both options are puketastic.Mine was meant as a joke.....I mean that that package deal exists lol haha right?!

Truly concerned And you weren't about the FT1? Both options are puketastic. Mine was meant as a joke.....

Better yet just order these and save some money. http://www.amazon.com/dp/B00R1PIJ3M?psc=1

Take one of your factory wheels off and stick a spacer in there just to check, should give you a close estimate.

Not sure what you are going to do with a "few" FT1 tweeters, odds are it will sound like ass. But since you are set on that idea match the Tweeter ohm with the xover ohm.

When I ordered wheels for my Denali I needed 30mm offset because its lowered, the Company sent me 19mm offsets (factory offset) . i installed them they are close the fender lips so i just raised the front and the rear up 3/8-1/2 inch. They rub the inner fender at full lock in reverse only. factory wheel was a 17x7 replaced with 22x9.5 so i dont think that 4mm less offset would really matter?

Had fun with these back in the day

Hey fellow forum go'ers, long time reader first time poster. Just recently pulled the trigger on a BL 12 cant wait for it to show up, and for some reason work thinks all the box calculator sites need to be blocked So here's my what i have BL12 d1vc powering it with a Rockford Fosgate T1000-1bdCP i need a box design max dimensions are 20Wx18Dx26H max its going in the backseat of a f-150 extended cab in place of the stupid little jumber seat behind the driver seat. If one of you fantastic box guru's could lend me a hand with a slot ported box tuned to 32hz i would much appreiciate it. I think 32hz is what im after anyways listen to most everything. Thanks all in advance!