Noobtastic14

thank you sir- i will use that wood instead of mdf whenever the money permits -Drew

SMD SSA Respek Mobile Audio Club Knowledge Realm TBC Ca Termpro **** but i only post projects on a select few of those Lighter, just as strong, less dust, beautiful! Splinters with cross cuts, is VERY unforgiving (small mistakes are hard to recover from, and get exaggerated when stained) and is more expensive than mdf -Drew

Sonys dont have the mechanical tolerance of nicer woofers- i would suggest 1.5-1.75cuft @38-40hz sub up port back in a jeep. -Drew

congrats on the purchase!! DC has always served me well customer service and quality are top notch Dont listen to OD- he is a n00b -Drew

No Autorama in Sacramento Feb 8th - 10th iirc -Drew

something like that! its a nasty driver- some kinks that need to be worked out but they will soon be a monster of a woofer -Drew

Just posting a follow up to the "Attention Noobtastic" thread in the DC area. Happy Customer Big Box might make it to Autorama 09 :ph34r: it was dark but i knew vids would be demanded soon enough lolz :yahoo: sounds good for only 700w (big surprise, always loud with DC) (Finish was left bare and some stubborn saw burns were left because he said he was going to cover it in fabric. If he decides to stain in the future i'll clean it up a bit more) -Drew

OD how far would you be willing to drive north for a little kick it? -Drew

Build the right box and DO NOT clip it and the woof should be fine :-) -Drew

LOL iirc the BTL is rated 1500 (maybe 2k? i forget) but it can take much, much more. my lvl 4 is rated a 1,000w sub and i gave it 2,800w for the few weeks i had it in. Just because i was laughing so hard from last post- i'll end with this. speaker fails for two reasons thermal or mechanical if your overpowering your driver you can build a box to compensate any woofer will burn with its rated power clipped to hell and over heating With clean signal and the right box you can overpower well built woofers quite a bit. Sorry for being off topic to the OP -Drew

Not if the car's moving... LOL @ U i'm doing 146s on jeezy and its nice hard to describe just build and bang -Drew

???????? -Drew

with new paint and rims that car could be sex on wheels. i'm looking fwd to seeing more of these around. -Drew

car: 1995 Eagle Summit (trunk) Electrical: 110A+70A alts two red tops big 3 in 0ga Amps: Crunch GP3000D Pro Subs: Single 18" DC lvl 4 Box: 7cuft @ 33hz w/2 6" round ports Mic: Termlab, in the winshield Tone: Young Jeezy Thug Motivation 101 (~40hz) Score: 146.6 drivers window down -Drew

if you don't have any experience then don't comment. Everything you said is enclosure dependent. x MF 2 Cant go wrong starting with an SSD or Q :clap: -Drew

seriously though- single 18 -Drew

It's a 6.5" maybe yours i have a solid 8" -Drew

thanks guys not bad for a single woofer setup -Drew

thank you sir -Drew

I got 4th in 139.9 after busting out against alpine. But I got to take Bill out in round 1 so that made my day 1-6th place finishers in 139.9 all qualified with a perfect score My scores for the day, 145.0 windows up 145.8 windows down 146.6 drivers down All on music (jeezy, ~40hz) Thanks DC for making a lvl 4 strong enough to hold 2800w rms -Derw

-Drew

i'll save you the time. its 40hz (or so i'm told at the comps) -Drew

lolz- 12.7 bats cold car off 14.2-4 with car on at idle -Drew

What voltage and current did you measure right before clipping? haven't gotten around to getting the #s yet. I just got my rockford 360.2 test CD back so i'll be setting it with a -5db overlap here shortly and will update with numbers then. 70A alt + 110A alt two redtops big 4/5 in 0ga 12.2 at idle after ~5min of blasting and 14.x constant while driving. bats sit at 14.4 at idle system off at 13.2 on 1A trickle charger and 12.7 just sitting -Drew

i'm not getting 3kw of clean power, but i would run a pair 3s conservatively on one in the right box. All the DCs are solid products and will take some heavy abuse -Drew