Liveyman

That amplifier will work just fine with the RL-p15's. If you use four drivers on that one amp, I'd recommend porting them with 3.1 cu ft of net volume/driver for maximum effect (since it seems you have your sights set for high output), though running all four sealed with the 2400 wrms will still make for a great setup. If you only use two of the 15" drivers, I would keep them sealed, though you could port them so long as you don't run the two ported RL-p's with the full 2400 wrms for hours on end, since that could put too much thermal stress on the voicecoil. If you are a cautious and responsible listener however, you could get away with the two ported 15" RL-p's at 1200 wrms a piece with 2.5 cu ft of net volume/driver... just realize that fried voicecoils are not covered under the warranty. Let me know if you have any other questions. <{POST_SNAPBACK}> You recommend 3.1 cu ft ported per sub . What would you tune the box to .

I posted this in the wrong forum earlier , so here goes again . I recently have started the search for a crazy spl set-up . Along the way I stumbled upon these subs called SoundSplinter . Always being one to give anything a look , I decided to investigate . I was plesantly suprised at what I found . What seems to be a quality sub at an even better price . So that is why I came here . I am thinking of going with either 2 or 4 15's . I will be powering them with a Directed 2400D . I am most interested in the RL-p 15's . Does anyone know if my 2400D would run 4 of these monsters . I am currently running two MTX 9500 15's in my Focus ZX3 . I am looking to use this as my daily driving set-up . Since this system is stupid loud as it is , I obviously need to go big if I am going to out do it . Any advice would be appreciated .

I recently have started the search for a crazy spl set-up . Along the way I stumbled upon these subs called SoundSplinter . Always being one to give anything a look , I decided to investigate . I was plesantly suprised at what I found . What seems to be a quality sub at an even better price . So that is why I came here . I am thinking of going with either 2 or 4 15's . I will be powering them with a Directed 2400D . I am most interested in the RL-p 15's . Does anyone know if my 2400D would run 4 of these monsters . I am currently running two MTX 9500 15's in my Focus ZX3 . I am looking to use this as my daily driving set-up . Since this system is stupid loud as it is , I obviously need to go big if I am going to out do it . Any advice would be appreciated .