jblcamry

dark tint.

http://www.youtube.com/watch?v=XBYv9r1KED4

baffle flex is the leading cause of screws breaking, tee nuts epoxied in place work well.

would be nice to see it on a tl.

I'm the silent type. doing great with the zcons. what does the car do in the legal position sealed and door open?

delta 10a's with some fi stickers :0

the dimenions on your pic have some conflicting measurements. on the rear view pic it shows a total hight of 17.25, but on the side it shows a combined height of 17.75, what should be adjusted to be the correct measurement. if i go off the back and adjust it from there i get 3.827528cubes if i adjust for the higher measurement i get 3.937454cubes

post dimentions and ill tell you what it is.

some testing at 27hz.

a db lower with the car running, and alt charging.

Did some fixing and upgrading in the geo a few weeks back. Little geo is back to being loud again. some testing on music, car off.

Just to add to this, the amount of cuts depends not only on the degree of the bend you desire, but the blade thickness. A thin kerf blade will require more cuts than a 1/8" wide blade. i have a calculator i made in excel that i will upload later that only works with 1/8" wide blades. you just input the desired radius and the degree of bend and it gives you all the info you need. edit: it can be downloaded here

around a 54 at 33hz with the voltage at 11.3 on the two 3kwp's at 2ohm strapped, with no trim panels(broke the back hatch with no panels). It now has trim panels but have not had a chance to do any more testing. Will update the thread when we do.

looks good where you can get to it with a roller, but it does show brush strokes because its so thick.