Brett Ebel

well I just checked and it was on input slave. so Ill test it tomorrow and see if that was it thanks

How would you do that. And whats the point of that?

I don't know what to do . Subs are wired and tested to 2 ohms. I looked up on how to test RCA cables and those turned out good if I did it correctly. Not sure on how to test your dead unit to see if the sw outputs are good. Any suggestions on that would help. I have a crescendo bc2000d amp power light is on. Is there a way to test the inputs on the amp?

ok so I just pulled by subs out of my box and everything is wired the way there suppose to be. The only thing I can think of is that I bought a faulty RCA cable.

That's my next step. To much work to keep pulling this box in and out lol. Ill get back to you if I cant figure it out.

yes, look I know how to wire everything up. Everything is done the way its suppose to be. Maybe I got another bad RCA cable.

Im sure. Ive double checked everything.

The old RCA's were old and broke. So I purchased new ones from KnuKonceptz. And no my head unit was not on. If I could id put up a picture on here but I Don't see anywhere to attaché a file.

Yes to all of those. they worked just fine about a month ago and I went out and bought new RCA cables. And now nothing is working but as I was plugging the RCA cables back into the amp I noticed a rubber piece missing on the inside of the terminals. So I was curious if that could be my problem?

I need help figuring out why there isn't any sound coming from my subs. I found out that there is a rubber piece missing on the inside of the terminals on my amp. Could this be why im not getting any sound and if so what should I do?