Sencheezy

3127 watts, 305a DC current draw, 154.1 @ 48hz

Well then, that escalated quickly. Just imagine at 2 ohms, with two amps, with three amps, with sealed sunroof, with stripper pole, and more alts. Holy shit so much potential!!!!

Yea I'm sure it will have different peaks with different amounts of power. . Need to get AOLT more power to them Damn, you think my peak will really change? I don't think peaks change with power? Peaks is determined by what the vehicle likes, no? I have had different peaks with different amounts of power in vehicles I have had. Could just be me lol. . . . . But I know in a couple different vehicles iv had did. . . . . . Like if you check your peak with your volume not up much at all then check it at full tilt. Iv had different peaks. Ok cool, I'll have to look into that then for sure.

Yea I'm sure it will have different peaks with different amounts of power. . Need to get AOLT more power to them Damn, you think my peak will really change? I don't think peaks change with power? Peaks is determined by what the vehicle likes, no?

look at all that ass

awesome score!!!

Don't forget, my last system was an 146-147 on the dash, on an BC5500 at 1/2 ohm. Sot that's what I'm comparing to. DB wise of course.

Ok, so I have numbers. Bad news, the amp that Rebel sent in for repair, is bad. So only one amp is working right now. It won't come out of protect and initially, there was mechanical fan noise only come out of that one amp. The amp went into protect when turning up the volume slowly. My truck has two peaks. 144.9 @ 57hz - 950w 145.0 @ 33hz - 1396w Again, this was all done at LOW volume. On the dash. BOTH doors open.

Had the same problem (caused a couple blowouts) . . . 100s of extra lbs are not to good for a vehicle lol. . . . Had around 800 lbs in my trunk. . I'm sure you got a little more than that though lol 2,000 pounds

The amps are mounted on a wooden shelf, which is hoovering about the terminals. At least what it looks like haha

Thanks for the comments guys! Yeah, suspension upgrades are for sure in my future. This has already been planned. But I had no idea I'd have an camber issue. I'm getting support bags sometime shortly after Slam, that'll be another 400$, then upgraded coil-over's as well, an additional 400$. Sigh, then of course the alignment as well. Thanks for the PIN Q!!

Here is a better shot

I have camber issues!!! Fuck

All wired up!

Wow, thanks everyone for the support!! Really on the last stretch here.

Plan is to have it playing Tuesday. Final testing by Wednesday. "Maybe" a stripper pole will be added before slam.

So loud!!!

Hahaha probably

Wires everywhere

Lol auto correct, bowman not blowman

Umm, what?Smaller version of Scott blownman RCA block

Got port area?

Custom mini cock block

Getting there