Everything posted by ///M5
-
Welcome to the IHoP
Completely stupid if you ask me. Why you would spend that sort of money copying an antiquated design with a non-original car seems a bit absurd. For the same dough you could have taken that completely normal car and turned it into something that is actually worth the money you put into it instead of just an orange turd with a big motor.
-
Change is needed in form of MJ-18's
Is your only goal output?
-
Hi From So.cal
I used to have an E36 328i. It was VERY easy to make 6.5" drivers fit in the kicks.
-
2003 Nissan Sentra SE-R Spec V: Project Spec-SQ
Since it is still in the car there could be some strange load in the car causing a ripple.
-
Welcome to the IHoP
Jeez I got tested when I lived in Illinois. IMO there isn't a better way of cooking that loin than cutting into chops of your choice thickness and throwing them on the grill with some kosher salt & pepper. As a whole loin it tends to be tough on the outside by the time the inside is done even only cooked medium, unless of course you use a smoker but then I'd rather have a butt with some connective tissue to break down and keep the meat lubed on the inside. So in other words, I wouldn't cook it whole. If you want to make it a bit fancier you could make some stuffing (stove top if you = lazy) and butterfly them. Fill them with the stuffing where butterflyed and roast in the oven until the pork is cooked. Probably around 50-60min at 375 or so, if they look done sooner take them off. I am not sure on the time since I pretty much would don't use the oven. It fucks with me, my charcoal grill on the other hand When butterflying a chop, I'd cut them into about 2.25 slices, then almost act like you are cutting it in half the long way (like making a 1 1/8' slice) but leave it connected like a hotdog bun. If you can keep the ends of the bun together a little better than the middle that is great. Adding some apples, pears, apricots, or peaches to the stuffing never hurts reduce the liquid in it a bit if you do this even though you still need enough chx stock to wet the bread enough to stick together.
-
Welcome to the IHoP
Thank god, otherwise I would have been majorly phooked in the SHO. Stage 3 cams and no cats are not going to help anything pass
-
Welcome to the IHoP
Ours are about as lax as they get. It was required, but then since so few cars failed they removed the requirement.
-
2003 Nissan Sentra SE-R Spec V: Project Spec-SQ
ouch
- maw12
-
Gain, Hz, and Db
i have no doubt my wires are run correctly..my friend told me that if the grounded negative wire is touching the power wire then it can cause heating problems. Idk if it worked because i havent run it since i seperated them about an hour ago. That doesn't even come close to answering my question, how about I make it more specific. What gauge wire are you running and to what do you have it connected to?
- Welcome to the IHoP
- Welcome to the IHoP
-
Welcome to the IHoP
By pork loin do you mean the boneless chops all together or the tenderloin? Or perhaps something else depending on how much of a dipshit your butcher is. Yesterday, I asked the butcher at the local supermarket here for some skirt steaks. He told me No Name bought them all and sold them in a box. I had him show me and he brought me to a box of sirloins and then proceeded to tell me that his short loins didn't include the skirt. (no shit being the short loin ONLY includes the tenderloin and strip). Hell the skirt isn't even part of a loin, it is part of the primal or underside of the cow and way under the loin.
-
2003 Nissan Sentra SE-R Spec V: Project Spec-SQ
You used these amps in your previous install didn't you? I assume there was no noise before?
-
Gain, Hz, and Db
1/5th means nothing. You either need an ear to hear distortion or a dmm if you don't have the ear. What are you using for power wires and where are they run to?
-
Hot amp
That amp should not run hot. Your installation is sub par and needs to be fixed pronto otherwise you will have a non-warrantyable failure on your hand quickly.
-
JL Audio Contacts Elemental Designs Over Patent Infringement Concerns
Depends on if the guts of the sub have something that JL patented. I hope so, I'd like to see eD and Icix go the way of the Low-Hz. Shady fvckers shouldn't be in business.
- Welcome to the IHoP
-
Welcome to the IHoP
Shoes make a HUGE difference btw.
-
Gain, Hz, and Db
*pukes in mouth You have your sub playing up to 175hz??? And you don't like the higher mids? If I set my crossover above 63hz I can't handle it, even though that is not going to help the false issue you have. edit: your problem is with your front stage by the way
-
and another hello
Welcome, you have a great start so far but you can ditch the rears.
-
Welcome to the IHoP
I love MN. That chit can't live up here. but you've got those damn mosquitos its the state bird
-
Welcome to the IHoP
i really wish I had a solution for you. I would connect just up to a remote battery though. If it is still there you know what it is.
-
DEH-P880PRS
I further made myself feel this way today. Independent l/r eq is nearly a necessity when running active. Regrettably, it makes a bigger stage difference than all my other efforts combined.
-
Welcome to the IHoP
I feel ya, that sucks completely.