im peeling off my old deadner ED v1 i know most of u frown upon this but it did provide some deadning but some pieces have kinda slid off not much but were they fell off jammed my lock to my door so hence the total removal... just wondering if u guys know any nice products to clean up my door n get rid of the residue oh and any input on new deadner would be great im looking in to bquiet and ramatt? not sure if i spelled it right thnx

The only good method i know of is using dry ice to freeze the material and then just breaking it off.

Other than that, its going to leave a nice sticky residue.

Goo Gone will take off the residue.

THere is another way that doesn't involve using dry ice , but using the product in the manner needed is illegal. You can use aircraft stripper to remove the goo

You can warm it gently with a heat gun or hair dryer - just enough to soften it, do not melt it. Should peel off pretty easily then. Sometimes you need to slide a putty knife under it to lift it off. Turpentine, mineral spirits or Goo Gone will remove the residue. Then you need to clean up the oily residue those products can leave with some denatured alcohol or acetone (I prefer the alcohol).

hmmm it gets pretty hot here in houston, should i wait till like mid day then start peeling? think that should soften it up enough just to peal off... i guess im gonna do that and use goo gone and denat. alch after... thnx for all the input guys

hmmm it gets pretty hot here in houston, should i wait till like mid day then start peeling? think that should soften it up enough just to peal off... i guess im gonna do that and use goo gone and denat. alch after... thnx for all the input guys

Can't hurt to try it that way. Very good chance it will be enough heat.

heat+tar based deadener= bad smells