k, i got a question,

im getting ready to order my amp(s)

and im considering getting 2 bxi 1608d, which would give 1100w RMS at 2 ohms

http://www.sonicelectronix.com/item_12211_...+BXi+1608D.html

i have the dual1 on the BLs, i was told i could only wire each at .5 or 2 ohms, or join them together and get 1 or 4 ohms?

so i decided to take the "Easier" way and choose 2 amps, 1 per sub

i am confused as to which would be the correct way f wiring these

so the correct way to wire this would be option 2 since its a 2ohm load, but it says the woofer is 4ohms(crutchfield)

but then the rockford has the 2ohm woofer at 1 ohm

anf both diagrams are the same?

so wat ohms would a dual1 be?

1)

2)

lol im getting closer to ordering my amp(s)

take the positive from one coil, connect it to the negative of the second coil. run the remaining positive and negative to the amp. it's called seriesing the coils, and in the case of D1s, it'll give you a 2 ohm load. per sub and amp.

wheeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee