Posted April 7, 200916 yr Say you have 2 4ohm DVC subs that you want to wire to a 4 ohm load on a mono amp.Could you wire each sub so the voice coils are in parallel, so each sub is wired to 2 ohms, and then treat them as single voice coil subs and run them in series to get a 4 ohm load on the amp?Don't think its hard question, just one i don't know the answer to. And this is definitely a place to learn
April 7, 200916 yr Two 4 ohm DVC's in parallel is a 1 ohm load.In series it is a 4 ohm load with all four coils.This site can be your best friend, http://www.the12volt.com/
April 7, 200916 yr Rockford Fosgate has a great wiring site also http://www.rockfordfosgate.com/rftech/woofer_wizard.asp
April 7, 200916 yr Say you have 2 4ohm DVC subs that you want to wire to a 4 ohm load on a mono amp.Could you wire each sub so the voice coils are in parallel, so each sub is wired to 2 ohms, and then treat them as single voice coil subs and run them in series to get a 4 ohm load on the amp?Don't think its hard question, just one i don't know the answer to. And this is definitely a place to learn yes
April 7, 200916 yr Author Sweet thanks! haha and thanks for the sites I was just sitting here thinking about my setup, and had that random thought lol
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.