sub in question here is a xcon 15

 

this is my first time using this or any sub enclosure design software

 

when i put in the qts, qms and qes parameters this is what happens:

 

 

 

Help a noob out!

dont fill in qts.  Let it calculate it itself.

^^^ What he said-  I hit tab after each entry- and if it autofills the next block(unless it is way off), I leave the calculated #.  Also inportant as a newbie to the program is to pay attention to the units of measurement next to the boxes. They can mess you up too.

thank you!

it corrected itself to .419

i tried that before but it didnt work, but this time i hit tab and i guess that did it

Edited September 1, 201312 yr by 1two3

It doesn't allow rounding so it'll error out if you force it to be rounded.