j-roadtatts

The neighbor's BMW. I like the midnight blue. always funny to see a beamer in a trailer park.

I listened for about 20 min on the way to work. I didn't crank on it yet but I DID still had an eargasium!!! I really think the BTL is going to be a Dr.jeckal/mr.hyde with the right settings. As far as things to still do in the trunk, I ordered some stinger fuse holders that use ring terminals instead. I lost the factory trunk springs to hold the trunk lid open, SO I need to install a gas strut. I DON'T like the way the loops in the battery leads look. So when I change the fuse holders I will make the leads straight. I also will probably dampen the trunk lid. As far as in the front of the car, I still need to dampen and LLP the doors. I am still playing with my fronts and deciding what direction I am gonna go. Right now I just need the get some y-adapter RCA's so I can bridge the F600 and get some serious headroom. I am working on trying different Phasing combos right now. I did get a RF Punch 400a So When I go active I can use that on the tweeters. LOTs and LOTs of headroom. Under the hood I just need to install a fuse on the 1/0 ga alt. power wire and some wire loom. So far my voltage looks OK. Only funny thing is my alternator shuts of about every 20-30 minutes for a minute or two since I installed dual batts. the RF amp and a Roll of 16 ga speaker wire. I have been reading about speakers for a LONG, LONG time now, and feel like I am finally starting to understand What it takes to get the front's set-up right for an SQ set-up. Slowly but surely. ALOT of trial and error, but I am a patient muthafucka.

Impious is a VERY helpful guy. When he talks, I listen. I honestly don't even go on ANY other audio forum's, The tech's on here REALLY help people to understand WHAT they are doing, NOT just tell them WHAT to do. Thanx again. Yes I am a young bull.

The trunk finally buttoned up. Here's a few pictures. The before. The last set-up, I never finished. This was a M650 and F600 amp. The trunk is done for the moment. I have a few other thing's I plan on doing though.

Heres a pic of the last set-up... And what it lOOk's like now. The left side.... The right side..... More pics on the way.

Next I had to Decouple the plastic pieces like the C pillars and the plastic piece over the sub. The LLP come's with a bunch of extra CCF on the edge's that doesn't have any vinyl. GREAT scraps for decoupling. Heres the pics.... The CCF glued where the plastic piece go's..... Another piece glued to the back ot the piece..... I Put taller plastic clips on to make the piece still fit nice..... The CCF and Damplifier under the right C-pillar...... No more rattles..... The other side..... No more rattle over here either!!!! The piece installed over the sub, and the rest of the upholstery!!!!! More pics on the way.

I got the sub installed today!!!!! AND I did take picture's. The LLP under the back set and rear wheel well's.... The front of the right rear wheel well covered in LLP, Wow, These piece's made the MOST difference yet in road noise. Definetly stopping the noise at the source, Short of buying quieter tire's. Like the Goodyear Eagles maybe. The left side..... The foam takes days to dry, I had to do a little every day for like a week solid to fill two speaker hole chambers. I put about 1 1/2 sheets of damlifier on rear deck but NO LLP. There was NO way. The carpet done!!!!!(finally) More pics on the way.