Bobby32

Well theres a big change in port length. 20.5'' to 16''

I miss calculated on my port and I am tuned to 29Hz instead of 32Hz. My box is ~5.3 cubes after displacements, I have 20.5'' of port (13.5'' in the box and 7'' out). I am going to cut the port down at the top. Will I notice an audiable change? I mostly play decafs chopped/screwed songs and I dont think they dip under 30hz, if they do its only breifly. Is 29 too low for a nightshade? Its ran off an AQ2200 @ 1 ohm

Beware of the middle seat. It is bolted to the two bucket seat and you have to take the whole thing out as one then disassemble. Then you have to re-install the bucket seats separately. The dimensions are all outer measurements. 58" W x 25" H x 7.5" TD x 11.5" BD Total of 6 cubes of space with the port being 4" x 10" tuned for 35 hz Mine just came off with a few bolts, but there is still a bracket sticking up a few inches. Got vids?

NICE! I like a alot! I though about doing something like that with my middle seat as well. The brackets on the floor are perfect for mounting something in place. What are the dimensions on the box?

haha its all good. My voltage isnt that great but it doesnt dip down too low. 13v-14v+ most of the time, I keep the gain low and dont clip it

lol idk, but I got it from a guy on caraudio.com. If you sold anyone an AQ2200, its your old one

Thanks man. crappy quality takes away from it though

I see, ill do it asap. Videos: Had to film with my 3mp camera phone sorry bout quality, still picked up some flex. Haven't fine tuned it yet, or experimented with many songs...just know this song is loud. http://www.youtube.com/watch?v=FQIo4BAnMAU http://www.youtube.com/watch?v=jqPKaBpEwOM

What can happen with my power wire bigger than ground? All I know is thats good to run same size wire, and same amount of runs. Yeah with all my builds in the truck, none of them liked being closed in. 1 door open works well...

True...might do the grounds tomorrow if I have enough terminals.

Pretty loud! Just got it all in today...did 1 of the big 3's as well, alt to battery It gets hella loud when I have driver door open. Def. doesnt like to be sealed up though. Still have to mess with tuning and all. Think my LPF and subsonic are off. Ill get a vid soon

Fits pretty good, seats aren't too bad. The middle seat fits perfectly and has lots of room for the bichs. Battery fits nicely on the other side of the box, and the amp is going to be mounted on the top. Going to get some wire tomorrow maybe and hook it all up. local prices are $5 per ft. for 1/0 or $7 lol ^^ Thanks, I havent really seen any big builds other than blowthroughs for single cabs.

up

I have 5.38 cubes after displacements other than port. My tuning is 32hz. I have an 8'' port going 12.75'' in the box, 12.75'' is my limit because I want 8'' of clearance from the bottom of port to bottom of box. Anyways, I have 12.75'' in and I have 7.8'' out of the box for a total of about 20.6'' of port. The port inside the box takes up .38 cubes so that leaves me with 5^3 inside the box after displacements. I think I have too much port length on the outside of the box, but I can still cut the port down. Any idea on what it should be?

Sanded off the old glue best I could but it still sucked painting over it. You can see the mis-colored looking spots are from glue.