brennermoore

Got my ssd's in yesterday, they seem to be closer to 7 inches mounting depth rather than 6.5.. not good news for me...

I set my gains by using a multimeter.

I have just heard underpowering can be much more harmful than giving them a little more then what they need.

Thanks, will have to save up a little bit of money before i start scraping it out on a new amp. But thanks again for the suggestions!

I believe that! haha... but didnt they use to only be rated at 800 rms?

My amp says it is 2000 rms x1 channel... I know that is probably not true, but i just dont know if that sundown would have more power than mine.. I know it is a better quality amp but still just unsure. Especially when it says these subs are 1000 rms each, so that would still be starving them from getting what they really want..

Also i got them switched too dual 1 ohm each, so i am going to be wiring them down to 1 ohm. I have not done any battery upgrades or the big 3 but that will come with time. I am going to try to push them with my amp for now but i know that they will be underpowered so a new amp will also come with time.

12"s.. box is sealed.

I did.. Hope for the best i suppose, thanks. Also the subs will have about .87 cuft a piece i know its not much but its the best i could do.. Do you think they will have enough room to still sound good?

Because i already ordered them ( they are still awaiting fulfillment) and i just was not thinking correctly and ordered them both as 2 ohm...

Also i have the autotek m4000.1d which is 2000 rms at 1 ohm (so it says)... do you think i could wire it down to .5, or would that just blow the amp?

Looks like the ap3000 is running around $400...Where can i find the MMATS amps other than ebay?

I have heard that there are a lot of problems that can come from running at .5.

I am trying to run 2 fi ssd's in my truck at 2 ohms... i would like to find an amp that is 2000 rms at 2 ohms... would like something cheap working on a budget here.. any suggestions?

alright, thanks.