Gnfanatic1

I would if I had the sub in front of me trying to do one stop shopping so I can work on the car all day instead of driving to stores.

Hey guys, sorry if this subject has been brought up in the past. Search engine is not working well for me. I am getting a 15" IB being built for me and want to mount it properly. I am going the T-nut route but do not know what size screws to get? 1/4in enough for 3/8? I dont even know what size the holes are in the sub frame. thanks for your help! Ralph

Thanks man, I would like to look at that post to get some ideas. Going to be ordering the goods very soon.

Guys I would like to mention that my seats fold flat. So I cant seal them and wont half ass it, leaving my new car alone. I will though seal alll paramters of the IB to the reat seat frame. Does this sound fine?? I would like to order the sub tomorrow but want to make sure a IB setup is doable in my car without butchering it.

May I ask what size holes you have to cut in the rear deck?? I am going to take some measurements for the hell of it

Sorry, no, not with one sub. 2 ohms is 2 ohms. Now if it were a dual 2 ohm the coils on the sub could be wired in parallel for a final 1 ohm load, or if you had two 2 ohm subs. Thank you. Will the ib15 be happy with 400 watts??

excuse my lack of knowledge in this area but can I get a 2ohm sub to 1 ohm load?? I can physically fit a 15 in my car. the driver will point towards the back seats.

Hey guys, So I have a Zed Audio Minilith mono amp thats rated at Continuous Output Power into 1 ohm 600wx1Continuous Output Power into 2 ohm 400wx1Continuous Output Power into 4 ohm 200wx1I am would like to build a IB setup in my cruze and buy the IB315 . Should I buy the 2 ohm sub and run 2 ohms at the amp?? I dont want to run 1 ohm due to heat and I only have a 140amp alt in my car with the big 3 done. OR would the IB312 sound better due to smaller sub?? I am worried about not having enough power. thanks for your input! Ralph

So guys we all agree on the Gcon line for IB setup??? 15" with 600 watts going to it, 4 ohm.

Thanks guys, I appreciate the help. If I am going to mount it right behind the seats I would perfer a single sub setup (15in) . right in the middle , behind the seats. I have a 600 watt zed audio amp I have the option of using as well. I believe I understand wehat you mean when it comes to reinforcing. I suppose 1.5 inch thick plywood with some additional bracing would be suffice to hold this sub?? Which model SSA SUB should I be looking at for this job? 600 watts, nothing exotic. I will close the 6x9 holes in rear deck with non-cut baffles and use something like dynamatt on the entire rear deck, trunk floor and inner fenders. Anything else??

Hey guys, I am looking for ideas/knowledge on setting a IB setup in my cruze. I have not purchased any subs yet. I do not want a box, do not want to break windows. Just want a nice solid punch. I am thinking going to a IB setup so I still have my trunk but not sure where to go for this. Against the seat's or maybe rear deck? Any idea's? Any of you guys have worked on a cruze? I have a zed audio 600 watt mono I would like to use to save money on this build. The rear deck had to empty holes in it (6x9) Not sure if I have room to enlarge the holes to put 8's. Need to measure. thanks!