illswag1619

Hey Everyone I've got a 745Li that I am bypassing the entire L7 audio system. The system is not what i want and i don't want to invest 1000 bucks just to put aftermarket amps into it. My idea is to first remove the ASK unit. Then fabricate the trim to fit a din size that will allow any aftermarket radio t0 fit. I'm sure the trim won't be strong enough to hold the weight of a head unit, so i need some of your ideas on supporting that weight. this part should be fairly simple. I'd like to cover the trim in an exact match of wood grain as the rest of the car but i have no clue where to go with that idea. I'll have to find an ignition and a 12v constant along with a ground. Any suggestions on which wires can supply me with what i need. The rest is just a matter of re wiring the speakers in the car to my new amps. so with that said, can any one give me some links to builds similar to what i'm about to take on. Thanks for any help.

did u kill it?

I'm not even sure. I havn't figured out what subs to buy for the doors. Any suggs? i want a kik ass mid, which is my reason behind the 8's in the doors. and sealing the doors up as much as possible with some second skin. Am i going down the right road?

You guys are awesome, Thanks alot

Awesome, i see the light! so how would i wire them down to get 1.3 ohms? series, parallel? speaker 1 2 3 ?

Hey wussup Guys, Can sumone tell me what would be the best way to power up and wire these subs together. I'm just about done making a fiberglass enclosure for them.its all one chamber. Should i use one amp two etc. The 3 subs are dvc 15" fosgate 2 ohm 250 rms P2d215 .After the box i will be making a panel on the door for one 8" sub and an 6-3/4 component set along with two component sets in the rear. Help me understand the science of installation. i want to blueprint the install but dont really know where to start. thanks