Test 1, 2, 3...

Spam.

OK I finally got them working but they sound like ass. Theyre Wired in 1 ohm according to a diagram i found online which should be 200watts(1k to each sub) and yet my 1000 watt ma audio amp between the two hit like twice as hard. I dont really have any idea what to do as far as adjusting an amp so any suggestions would be great

European retailers to guarantee what should I do? must send you the material? or find a repair center here where we have it repaired? in this case the cost of repairs will be addebbitate you pay us or the dealers? we can have explanations for the guarantee for us Europeans?

ern...........................

If you want lightweight, Baltic birch ply in 3/4" will be the same or less weight than a 1/2" mdf enclosure. Considering weight & SQ are your paramount issues, I would 1) Limit the enclosure material weight, obviously IB is best, small sealed 2nd, 2) Pick my driver based on what it can do, but also with enclosure size as part of the equation, 3) Limit the overall weight of the driver as this will make a HUGE impact on the overall weight. So what am I saying? I'd use a different sub and just a single one. That will give you more weight savings than looking at just the thickness of the enclosure. If you do use both, I would argue that you aren't that concerned with …

Updated 3-19-09... will be adding more stuff later.

Exactly. That why if I were to upgrade to 2 of them then I could set it to 2 Ohms.

spam

IIRC the Brahma had 3 slugs instead of a really tall top-plate (like the 02-025 xxx) because of cosmetic reasons.

My guess is 896

PM sent

That is true. You should ask ***** ***** what he likes better. He used to have the btls and switched over to the mayhems. Join the **** forum and ask there.

Recieved my SAZ-1500D yesterday, and I'm very happy. This thing is nothing short of awesome. Thanks for making such a great product Jacob, very much appreciated. Great customer service and fast shipping, thanks. I'll always use Sundown Amp's in the future.

.

but seriously I hope he gets better, suicide just isn't the right way out

I clamped my first 1000 a few weeks ago, I figure I'll put up what I got. Stock Alt Yellow Top Under Hood Kinetik 2400 in rear Resting voltage at 13.6 ....... I had just been doing TL testing and batts were dead With 2 L7 15"s wiring to .5ohm I got, 1080 watts with drop to 12.9 and imp rise to 1.8 ohm. I now have two of these little monsters and will be doing some more testing soon

I don't care who you are, that's funnt right there!

All items listed before sold... will update again some time soon.

I've been installing and fabricating for a long time...

Kryptonwhite has some more WIN worthy content for you M5.

It will only let me upload one pic

Still more to go!

Its 4.5" LENGTH after the corner of the port. Not width. It's stilll 5" wide. Nice design! Not talking about the length that is given. 15.25" port wall + .75" for the second wall = 16" 20.5" of internal depth - 16" = 4.5" away from the rear wall. Not to mention if it was 5" from the back it would be tuned to 34hz