General Audio
An Open Forum Dedicated To all audio questions that do not fall under the other specific categories.
3,954 topics in this forum
-
So i ended up picking a soundstream XXX up from my buddy mario on team soundstream, he had it in his wall and was on his way to a buddys b4 they were done and it wasnt secured all the way so the box flew fwd and damaged one of the subs, but it was just the cone...no the voicecoil, spider or tinsel leads, those are all still hooked up and the sub works ha but im not sure if i have to do a full recone or not, i heard id be fine getting a new surrond and dustcap since i am only gunna be givig it about 3-3.3krms so no where near its power limits, but i was wondering if there is a easy way to get the remaing cone of around the voicecoil, this is going to be the first sub i hav…
-
1
Reputation Points
- 25 replies
- 4.9k views
-
-
I'm getting a LOT of spam attached to the home address of ssaudio....can you enlighten me a bit Aaron?
-
0
Reputation Points
- 9 replies
- 1.3k views
-
-
I have an amp and a pair of speakers and im not sure if they are good or not. What would you guys rate them from 1/10, i got them both for free so im not to concerned if they are good or not. Speakers - http://www.sonicelectronix.com/item_3230_P...1-2-+4-Way.html Amp - http://ampguts.realmofexcursion.com/Alpine_MRV-T502/
-
0
Reputation Points
- 10 replies
- 847 views
-
-
i am thinking about getting speaker replacements for my oem door speakers. i got a 96 honda accord coupe. these are the two i am looking at right now: ALPINE SPS-600 6-1/2" 2-WAY 240W and KICKER KS60 6 1/2" 2-WAY 195W. which one is better and maybe if someone else has a better set tell me. these two are only 10 dollars apart on ebay. they sell for around 50 shipped.
-
0
Reputation Points
- 1 reply
- 665 views
-
-
I searched a couple of weeks back for a converter that would allow me to put 6.5 inch midbass drivers in the doors of a tahoe and was able to find it. Now I am ready to purchase them, and I can't find them anywhere. I found them on ebay, but after hours of searching I can not find it. The speakers in the door are built into a plastic type converter so they can fit into the hole. I just need aftermarket ones so that I can install a standard 6.5 inch speaker into the door without any modification to the door itself. Thank you.
-
0
Reputation Points
- 10 replies
- 840 views
-
-
ok after a bit of research ive decided to try something alittle different then the standard 2 way with a mid and tweet. what i'd like to attempt will use a midbass with a small full range driver. current stuff equipment- Clarion DXZ785USB, kicker 100.2, kicker 250.2, pg rsd 6.5" components. door treatment- 2 layers of raammat on inner and outer, plus a layer on door panel speaker location- mids in doors, tweeters in diy a-piller pods aimed towards the middle (driver sides about 30 degrees off axis) sub stage- AA arsenal but usually i have it turned down and blended in unless im feeling like some rap... --------------- plan is to throw the biggest and baddest midbass in…
-
0
Reputation Points
- 31 replies
- 3.1k views
-
-
Hello, so I have a dodge charger Srt with the Boston setup. I took the kicker sub outta the trunk and put in my Fi BL. When I get home from this deployment I'm looking at changing all of my inside speakers. I'm look for sound quality. The bass is there, but I want the inside to be very clean! Help me choose my setup. I'll go with 6.5s in the front door and 6x9s in the back dash. What brand and models and amp do you recommend. I'd like to get it done under $1k but that's flexible. Do you think I should add more tweeters, there is only one set in the factory setup. I'm keeping my factory NAV. And I'm looking at a JL clean sweep or Rockford Fosgate 360.. All options are welc…
-
1
Reputation Points
- 9 replies
- 1.7k views
-
-
For your comp sets and or speakers that you have in your doors what gauge of speaker wire do you use and what brand? I was looking at Knukonceptz Karma and Klear wire 12 gauge. Please share what wire you use.
-
0
Reputation Points
- 3 replies
- 785 views
-
-
I have two different brands of speaker wire that are turning green inside the jacket. It is not turning green at the ends just in certain areas of the covered wire. Ive spent two hours googling and just seen multiple forums and websites where it turned into an argument whether the discoloration was due to oxidation or the chemical reaction between cheap insulation and the copper wire. Please don't turn this into a pissing contest. Either you know or don't know, don't need guesses. What causes the discoloration and will it affect the signal if used? Remember its not at the ends, just restating that for the people who can't read. One set of wire is brand new and it came lik…
-
1
Reputation Points
- 8 replies
- 2.1k views
-
-
Ok Hello, I have my amplifier already picked out. I've been researching this for about a month or two and am stuck on a few areas.... being pretty new to car stereos I come to you for help. The amp I have chosen is the Viper D1200 and I'm debating on my speaker selection, its between 1 Alpine 10" Type X dual voice coil and 2 Alpine 10" Type R duals... I plan to run this amp at 1 ohm. I listen to mostly death/black metal or metal in general so SQ is what I'm after mostly but I occasionally listen to some rap and I would liek a decent compromise between sq and spl. Basically I am looking for something with the ability to get really loud if I want but will run my metal fine …
-
0
Reputation Points
- 26 replies
- 2.8k views
- 1 follower
-
-
Just scooped a '98 Mountaineer this morning. Has the 5.0, it's AWD; feels good to be off the shoelace express Plans are a singer 240a, some royal excelene, a juicebox 20ah under the hood, Three SI mag v3 12's sealed (amp undecided), silver flute 8's in the doors, and hlcd's under the dash on a PPI 900.4. Doors first, but intend to fully dampen the cabin, mlv, ccf, cld, and foam. Want to sniff out an 80prs and snag a minidsp also. I'm so geeked.
-
2
Reputation Points
- 25 replies
- 4k views
- 1 follower
-
-
Are there any good front speakers that can be run off of my head unit or do i have to get an amp.
-
0
Reputation Points
- 3 replies
- 1k views
-
-
well I have my new amp.(from gntar) SPL2-1200. so now i'm wondering what kind of speakers and subs would work well? need some new 61/4" for the front doors. i was thinking of a component set but i'm not sure. also what subs to get. i was thinking of getting two 10"s. if possible i'm trying to get all this for under 500. any ideas? Jeremy
-
0
Reputation Points
- 6 replies
- 904 views
- 1 follower
-
-
So i was just rear ended 2 hours ago at a red light. I have a 2004 chevy blazer and was the first in my lane at a red light. the guy next to me jumped and the girl behind me floored it in her dodge stratus. When it happened, my door speakers popped and do not work anymore. the fuses are all good, my amp still works as do my subs. So, i'm thinking about buying some raw drivers from Parts express and trying myself at an active 2 way since i have a Pioneer DEH-P880PRS. Anyone have any good suggestions for under $200 total? I've been looking at Vifa tweeters and Dayton mids because they are so cheap and yet model really well in a few programs i have access to. Thanks for any …
-
1
Reputation Points
- 12 replies
- 1.1k views
-
-
Got the system up and running and upgrading my alpine mono amp with a sundown 1000d. Sub amp is disconnected right now. Gains on my 100.4 are set very moderately. Around volume 44 on my 800prs my speakers will shut off. There is no pop or to the ear sounds of distortion. I just drove back up to college and did not get any times of cut off. It has happened on both cds and ipod. Could i just be playing it to loud? Also, i have a d3100 up front and the big 3 upgrade with 0 gauge. Any ideas would be very appreciated. Best Regards, Steve
-
0
Reputation Points
- 54 replies
- 4.7k views
-
-
What does these mean on subs? FS RE QMS QES QTS SD RMS CMS MMS BL VAS XMAX XCOIL Please tell me what each of those mean if you can!!
-
0
Reputation Points
- 4 replies
- 599 views
-
-
What's a good Spectrum Analyzer to start with??? Something cheap to start with (to adjust that EQ I'm getting soon).
-
0
Reputation Points
- 13 replies
- 2.2k views
-
-
Hey Guys Theres A Daddy Long Legs In My Enclosure. Can See It Through The Plexi Glass Who Thinks I Can Blow It Up ? It Started To Shrivle With 100 Watts
-
0
Reputation Points
- 23 replies
- 1.5k views
-
-
Answer: YES!!!!
-
1
Reputation Points
- 29 replies
- 3.8k views
- 2 followers
-
-
-
does any one know where i can buy a cheap mic for spl and software ? or maybe some one has one for sale ?
-
0
Reputation Points
- 4 replies
- 693 views
-
-
why does box bracing make the box quite?
-
0
Reputation Points
- 2 replies
- 714 views
-
-
are these any good? or are they high powered fart-cannons? two of dese on a SAZ-3kd? worth the time it takes to setup? http://www.stompaudio.com/spl-15-2800-watt...3a79638fda3eed3
-
0
Reputation Points
- 2 replies
- 568 views
-
-
my question is which subwoofer would be better for me the ssa xcon or the sundown nightshade,my setup will be running off a saz 3500.Now i have heard the xcon`s there great woofers but i have never heard the nightshades.Its a dodgr charger daily driver.It will be 12 inch woofers unless i can squezze 15`s in my trunk..Thanks for any help.
-
1
Reputation Points
- 17 replies
- 1.2k views
-
-
First off I know how to make a sub sound good but little about SPL. I built my son a Power Wheels vehicle to compete in MECA Kids. We have won two World Championships with it. Both on the drive-by section. It is an open dunbuggy type Power Wheels. It does not meter well inside because there is no dash. BUT because it is open we usually take drive-by. This year there are already two scores over what we did to win finals. Currently there is a 12" DD 3500 I believe it is with 1400 watts. With the success I have had with the Fi's in my car i want to switch over this year. What do ya'll need to know to start this process? later! Kirk
-
0
Reputation Points
- 4 replies
- 781 views
-