Amplifiers / Head Units / Processors / Electrical
Discuss Head Units, Amplification, Processors, And All Electrical System Inquiries Here.
5,712 topics in this forum
-
Does anybody have any experience with them? Do they do rated power? I have heard rumors, but no proof, about the earlier models not making rated power. How reliable and durable are they? I have never used Hifonics so I am a little curious, I am thinking about getting 2 of them.
-
0
Reputation Points
- 7 replies
- 1.8k views
-
-
Hooking up a second battery is something I've never done. Do I run a wire from the starter battery to the secondary battery. Or do i run a wire from my alternator to the secondary battery. What kind of fuse do I use? More than 1 on each end? Thanks
-
0
Reputation Points
- 7 replies
- 1.2k views
-
-
i was playing around with my headunit(pioneer 860mp) and switched some things that made it hit the hardest of ever!!! but i took my magnum out and looked at the coil and it looked brand new un harmed!!!(even with me turning the gain a little higher than the head units voltage) i have a bx1500d i think that i want to step up to a bx1800d or an audiobahn 1800dt will i notice it? audiobahn vs hifonics amp wise or is tunsumi a good amp?
-
0
Reputation Points
- 7 replies
- 1.5k views
-
-
I have been researching the Diamond amps. Should I go with the new D6 line or the discontinued D7's?
-
0
Reputation Points
- 7 replies
- 989 views
- 1 follower
-
-
Okay, So here in a few days Im ordering two subs.... Either the Maw-15's or the Eclipse SW7200. Both of which are rated 500w Rms. So I have picked out some Amps that caught my eye to use to push them. Take a look and tell me what you think. Please feel free to inform me of other Amps from which I did not list. MONO ___________________ Memphis 16-PRD1000.1 HiFonics 1606D Sundown SAE-1000D Us Amps XT-2000D 2-Channel ___________________ HiFonics ZXi 1006 So yea...... Thnks in advance
-
0
Reputation Points
- 7 replies
- 1.1k views
-
-
I got a 9885 a week ago and was installing today. It's going into a 86 Mercedes so I connected everything temporarily to make sure the wiring was correct. After setting it up and running it for about 10 minuets the rear heat sink was to hot to touch. Normal? If not what might be causing this or do I need to return to BB?
-
0
Reputation Points
- 7 replies
- 1.7k views
-
-
I found out that http://www.Darvex.com offers everything needed for your car audio setup, but i dont know everything i need. I know i need my alternator (ebay) batteries (Darvex) 1 Gauge Wiring (Darvex) but i dont know what else. Car: 1997 Nissan Maxima *No Bose Audio Package Trunk Dimensions: Width: 40 inches Depth: 28 inches Height: 16 Inches (Here are some pictures) http://i55.photobucket.com/albums/g149/Ore...k14/H011305.jpg http://i55.photobucket.com/albums/g149/Ore...eak14/H0113.jpg My goals: I just want to have a loud sound system, so I pretty much want to max out my maxima for a budget of $2500, this includes the subs, amps, comp speakers, deck, raammat, wiring,…
-
0
Reputation Points
- 7 replies
- 1.2k views
-
-
Im considering on buying one of these head units and would like to know if you guys have any opinion on which one you think is better. In terms of sound quality, functionality, features, ipod use
-
0
Reputation Points
- 7 replies
- 1.7k views
-
-
Hey guys, i was thinking about getting a Powermaster D1200 for my system... As of right now... i have a RF p5002 going to a 12" w3. When i have everything cranked up i notice my lights dimming a little bit... Yes i have factory wiring... but also i have a peice of junk battery (not sure exactly what it is but it was the cheapest thing i could find when i bought the car) although the car does have a 110amp alt. (i will be replacing the battery i have right now) My question is this... Will that help out my dimming situation with such a small amount of power being taken from the p5002. Within the next couple weeks (once my turn comes up in quentins long line) ill be switchin…
-
0
Reputation Points
- 7 replies
- 704 views
-
-
What can happen if to many things are hooked to one remote wire? . . . Every once and a while my amps will shut off like there protecting and sometimes the cd player will shut off but volts will be in the low 13s . Could this happen from alot of things hooked to one remote? . I have both sub amps. My 4 chan amp. An eq and both volt meters all from one remote
-
1
Reputation Points
- 7 replies
- 789 views
-
-
What kind of Parametric EQ do you guy's recommend? I have a clarion deck, it only has 2 volt pre-outs but its loaded with options such as you can rip someones cd directly on the deck, SD card mp3s, Ipod etc etc. Anyway it only has Bass and Treble for EQ therefore I want to either get a Parametric EQ or maybe one of those high speed 30 band eq's with the clipping light on each band, What kind do you guys recommend? money is a concern and its gotta be black Also where should the eq on my deck be set at when i get one 0 for bass and treble or -6 for bass and treble? I would also like it to be a min of 7 bands
-
0
Reputation Points
- 7 replies
- 814 views
-
-
I just aquired a DieHard platinum group 35 battery. I also have a kinetic hc600. Would they be safe to run in parallel together?
-
0
Reputation Points
- 7 replies
- 1.8k views
-
-
I current have a stock battery up front, and a batcap 2000 in the back near the amps. my question is, would there be any problems mixing battery brands? was looking at a kinetik 1400 to put up front.. would it make a difference? I would assume not considering the stock battery i have up front (wet cell) runs fine with the batcap in the back minus the voltage drops. I need to figure out a way to stabilize these voltage drops. Thanks guys!
-
0
Reputation Points
- 7 replies
- 941 views
-
-
Well people I am debating to whether to keep my Arc Audio amps installed or take my Zapco DC amps out of the closet and swap the Arc Audio for the Zapco DC. If you were doing the SQ build which one would you do? Thank you Ebrahim
-
0
Reputation Points
- 7 replies
- 985 views
-
-
I let it sit for a bit and I guess from what I read online that if it gets a little dust on or in it. The cd player doesn't eject cds. There is a disk in there that plays fine. It can't eject it though. How would I fix this?
-
0
Reputation Points
- 7 replies
- 1.1k views
-
-
Has anyone on here ever used a computer as an audio processor? I want to have a rockford 3 sixty style audio processor in my truck and was thinking that i have spare computers and i have heard of people putting imacs in there cars in place of decks so that got me thinking into what expansion cards/audio programs are out there for such purposes? anyone have any thoughts?
-
1
Reputation Points
- 7 replies
- 669 views
-
-
I have some pioneer speakers that rms at 40w and I have three amp choices that are in my price range what would be better Mb quart onx4.60 @$99 Alpine mrp-f300 @ $149 Kicker dx200.4 @ $149 Please help
-
0
Reputation Points
- 7 replies
- 793 views
-
-
okay i have a boss 1600 watt amp hook up to 2 10" CVT kickers, sealed box, in a 2007 Ford F-150 i know that there is a lot of forums disusing this same topic but i don't seam to understand. What should my Input Lever, bass boost, and Frequency
-
0
Reputation Points
- 7 replies
- 1k views
-
-
alright so theres a problem that bothers the hell out of me I want an amp I am stuck between the sundown saz-1500d and the audioque aq2200d. the audioque does 2200 at 14.4v Im aware that that it would be almost impossible for me to keep that voltage .SO my main question is which one to get does anyone know what the audioque will put out at like 12.5 to 13 volts thanks for the help guys.
-
1
Reputation Points
- 7 replies
- 3k views
-
-
I'm getting my fully loaded Fi BTL N2 18'' soon. I'm still not sure what amp to get without overpowering or under powering the BTL. Do you think 1 Rockford t2500bdcp would be too much for it (it put out 2500watts at 1ohm and 2 ohm)?? Or also im thinking about getting 2 rockford T1000bdcp's (which puts out 1000watts at 1ohm or 2ohm) and hooking up one amp on each coil on the BTL. Let me know what you guys think Thank you
-
0
Reputation Points
- 7 replies
- 1.2k views
-
-
So my question is, how many have tried a 12v battery with a 2v battery in series to get 14v and charge at 16.3-16.8 volts... And this would be a daily / spl setup. so let me hear all the pro's @ con's, I think it would rock
-
1
Reputation Points
- 7 replies
- 1.1k views
- 1 follower
-
-
I will be running a memphis 16-2000d on a old style 18" btl. I also will be running a 400 watt kicker amp for 2 CDT component systems. I have a 200 amp alternator and i just ran into a deal for two D34 red top optima batteries. Will one red top in the front and one in the back be enough to support my system? All will be going in a 1996 gmc suburban. I know yellow tops or kinetiks will probably be better, if the red tops wont be good enough anybody know were i can get a deal on something better?
-
0
Reputation Points
- 7 replies
- 783 views
-
-
If I'm trying to do a 2 way front stage. With a 3 way crossover that has the hpf 's I need for the Mids and tweeters how would I cut them off where they need to be if I have no controls on the amp for them? Subs are from 25-60. So was going to cross the Mids around 60. And tweeters around 4-5 k ......
-
0
Reputation Points
- 7 replies
- 800 views
-
-
Okay heres the deal.. i should within the next 2 hours or so recieve my two Powerbase xs 15's from ups.. I want to use crossfire amps.. your not gonna change my mind. any how I've been looking for a deal on them. And not on ones where the red light is on or it accidentally fell out of your truck on the free way, but you think it still works lol.. preferably new wit ha warranty. I'm working on building a show truck.. well daily driver/show vehicle. Here's what I'd like to accomplish 1993 ford explorer.. to be painted electric blue as soon as i get a free weekend to start body work.. rain = yuck 4x powerbase xs 15's - have two so far. will buy the other two if i can find a …
-
0
Reputation Points
- 7 replies
- 2.1k views
-
-
Ok i'm getting a saz 3000 and a 250 alt now i need to know which battery you guys would suggest i'm lookin at kinetik and optima but don't know which one of either any suggestion thanks
-
0
Reputation Points
- 7 replies
- 1.1k views
-
Who's Online (See full list)
- There are no registered users currently online