Amplifiers / Head Units / Processors / Electrical

hey i posted on another forum the question on wether or not it was a good amp for $250 i am buying two kinetik 2000's and i have 0ga wire all around my alt is stock @ 80 to 100a. i am only looking for about 2000 watts because i have 2 fissd's. i got responses back this amp is a current hog and i need to run it @ 17v to get it's full potential but i dont need the full potential, besides arent all amps that provide 4k worth of power current hogs? how do you guys feel about this amp for daily 2k on the electrical set up i have?

i just wanna know if anyone thinks this is good for about 2000w on stock alt puttin 13.9-14v idle and 14v+ engine rev. with 1000cca starter bat and kinetik 2000 in back all 0ga big three and such. i am not a competitor, not lookin to get the full 4k out of the amp, before everyone starts saying how you have to run it at 18v to see 4k. just wanna know if this is good enough to get 2000w for 2 12" fissd's. i have done searches also before i get flamed for this, but the few that wasn't bashing this amp were old ones for sale or people trying to get the full 4k from it, or modding it for 1 ohm use. dont need all that just 2k is fine for me, thanks.

Has anyone here heard of it or used it? It seems a bit old but IDC much about that. As long as it works. What do you guys think of it? does it put out near rated power? Don't these have a lot of current draw, and are power hungry? LMK because I think I just found a HECK of a deal on this amp... Powering a Fi BTL, wired at 1 ohm but will most likely have the gain alll the way down. looks a little different than the 5082 I've seen... He called it the 582hx, no google searches came up...

my 4 channel HK598 blew. im not exactly sure what the problem is, but its not in protect, it powers on, but no music...something prally broke becuase of the voltage drop. i put the powerbass xa3000d in....as soon as the bass hits, bam, voltage = 8v! this is on the stock electrical though. the powerbass is holding up like a champ, i have it off now though til i get home so i can put my hc2400 in after work, hopefully thatll help....i also emailed EA about an alternator. i really hope the hc2400 helps though in retaining power to at least 12v while the alt can recharge it....becuase right now the voltage drop is just ridiculous. its loud though. 15" treo ssx in like 4 cube…

will it work? we tested it at 12.8v on a 1k hz tone, and it did 300w rms x 2 @ 2 ohm. its rated at 500w x 2 @ 2......that was at 12.8v tho.

My friend keeps on telling me his ma audio 802sx pushes out all this true power at less than 14 volts. I told him his amp was rated at 17 volts and he doesn't believe me. How does the sundown saz-3000d stack up to the ma wattage wise at 14 volts. He says his amps are the better deal because they are a little more than half of the price of the sundown. I told him you get what you pay for and sundown was a better quality amp. I just need some opinions and facts to back up my logic. Any help would be grateful.

I have been wanting to put a mac mini in my car for a while now but still have a few questions. First off, would I need a head unit or could I somehow just use a amp and a sound processor? If so how would this be done? Second what are some good 10" touch screen monitors that will work well with a mac mini?

I'm installing my AudioControl DQXS and setting up my active system. As a total newbie to this active stuff, I'm crossing one huddle at a time. The first thing is a major, and I mean major noise issue. So bad that it sounds like a test tone being played when the system is at 0 volume. With the vehicle running or not, it only changes in tone. I finished up late tonight and have not been able to do much troubleshooting. I did play with the internal (jumper) ground settings on the DQXS without any success. I was in a bit of rush when I wired it so here's what I did. I daisy chained the power to the DQXS off one of the amps. A 4 gauge wire from the battery to the amp to the …

I am buying a yellow top from my friend. It is taller than my original battery and the wires won't reach.

Crunch Powerzone P 900.4 4-Channel Amplification 900W 2 / 3 / 4-Channel A/B Class Amplifier 115W x 4-Ch @ 4-Ohms or 225W x 4-Ch @ 2-Ohms or 450W x 2-Ch @ 4-Ohms Dynamic Music Watts we have this and (2) IA 187 12"s ..... dual 4ohm. what do i need to do to wire the two subs in order to get the most out of this amp? thanks Chop

Alright, I'm sort of confused, and have spent hours/Days/weeks trying to figure this all out, but I'm sort of just in between ideas at the moment. I was told you guys were the best, and so I've come here! If you have any ideas, any help would greatly be appreciated. and I've tried to help out as much as I can in terms of information.. So essentially I'm at the stage where I already have; HU - AVIC-F910BT (http://www.pioneer.eu/eur/products/archive/AVIC-F910BT/page.html) Which for quick reference has Front, Rear and Sub pre-outs. 6x9's - JL C2-690TX (http://www.elite-electronics.com.au/In-Car_Entertainment/Speakers/Rear_Speakers/JL_Audio_C2-690TX_6x9_Speakers#.UgkNupIy1…

Hello, iv just been looking around for a battery and oddly enough i found a marine AMG battery in my dads garage. Its a Cabela's Advanced Angler "Group Size 30" battery. Heres a link showing all of its specs. http://www.cabelas.com/product/Boating/AutoBoat-Batteries-Chargers/Marine-Deep-Cycle-Batteries|/pc/104794380/c/104698080/sc/104446080/Cabelas-Advanced-Angler-AGM-Batteries/727395.uts?destination=%2Fcatalog%2Fbrowse%2Fboating-auto-boat-batteries-chargers-marine-deep-cycle-batteries%2F_%2FN-1100564%2FNs-CATEGORY_SEQ_104446080%3FWTz_l%3DSBC%253BMMcat104794380%253Bcat104698080&WTz_l=SBC%3BMMcat104794380%3Bcat104698080%3Bcat104446080 Now seeing the amp rating an…

Someone is selling it for $400. I wanted to know what is anyones experience or info in regards to this amp. I was not able to find anythingthrough google or yahoo.

Has anyone used or have experience with Mark Antony amps. I have 25opcm, I think not sure. I just want to know if I should go with a different amp(do not know specs of amp). I will be running different subs for daily and comps but they both should handle 1000 watts.

So my buddy just got out of prison after 6 years in and he is selling alot of his stuff...he has an amp ive never seen before...mark antony 3000d? Are they good?...i opened it up and its mint....he wants $100 for it...does anyone have specs or know wtf is up with this amp...

I just got it off craigslist for a $100, its rated 150x1@4, 300x1@2 and 800x1@1. Are these underrated? I wanted to know because i plan to buy a Fi Q. thanks.

I have a Mark Antony Gspot GS754S. I can't find any information on it! Can anyone help me? Any information would be appreciated!

Anyone know of a good amp repair place that might be able to fix an old Mark Antony 25OPCM? I found a phone number for Concept, I believe they bought them out years ago--but haven't had a chance to give them a call. I would REALLY like to get this amp repaired if at all possible.

anyone had any dealings with them? Just wondered what kind of quality and workmanship they put into there products?

are these amps any good.. looking at the nano series... well the issue is that the nanoblock 4 claims to be 2000 watts rms cea compliant but only costs 279.. does any one use these amps or know anything about them? cause that price is really fishy for that amount of power

I'm looking at maybe picking up the N4 which is Massive's new Nano line. Was wondering if anyone has experience with the Nano line. I've had older lines of Massive amps and I think they are fine, but never tried the Nanos. Wondering how hot they get.

hey I ran across what I think is a good deal. Its for a massive P3000.1 Im wondering how good of an amp is this, and how good of a price is 400 bucks? I cant seem to find much about it online so I figured I would ask here. Also, would I need a new Alt to run this amp? thanks

Anyone have experience with the massive audio P30001? http://massivemulti-media.com/store/index....p;products_id=4 The prices are very low right now on e-bay and it looks good. If it's as good as it looks does anyone know if it can handle say a 1.4 ohm load with good power supply or is it a rigid 2 ohms? I was thinking of running one of these to A btl 15". what do you guys think? Hope this makes sense I am undercaffenated.

OK, here is scenario- Got a 20A relay on remote turn on wire with 3 amps and some leds on it. The 15A fuse on the relay popped today... that means it drew WAY too much current... i have a short somewhere... I check- 3 wires were pulled out of the remote turn on distro block that was reading ground.... 1 of these wires is an LED wire. The other 2 wires go to my sundown 100.4 and the other wire goes to both AQ3500Ds remote turn on... The LED wire reads 0.0 ohms and the turn on wires for all 3 amps are reading 0.2 ohms.... Is the remote turn on's grounded? Did the led wire cause a massive surge through all the remote turn ons?

Someone in my area is selling one, and I'm just wondering if anyone knows anything about em'. It's rated 800 @ 1 ohm, but I'm not too sure haha